The front step on my 1999 U320 will not close when engine started and door is closed. It is an air actuated step but where do I find the controls to fix or replace?
Thanks.
Richard Anderson
Take a look at these previous discussion threads for some possible answers.
http://www.foreforums.com/index.php?topic=6936.msg29834#msg29834 (http://www.foreforums.com/index.php?topic=6936.msg29834#msg29834)
http://www.foreforums.com/index.php?topic=4487.msg17952#msg17952 (http://www.foreforums.com/index.php?topic=4487.msg17952#msg17952)
Is this a new problem that suddenly happened?
Control valve is behind step.
Thanks for the information. I'll check out the control valve and see what I find.
Richard Anderson
perhaps the contact on the screen door is not making contact, with it's
counterpart mounted in the stairwell, when the door is closed.
Several weeks ago I posted a request for help on a front step problem. The problem has been solved by installing a new solenoid valve and pressure regulator/gauge which I bought from Foretravel. The new valve looks much different than the old one ( on a 1999 U320). The solenoid valve is made by Norgren. The new one is somewhat longer than the old one and does not come with any instructions. However, it is not difficult to figure out. The electrical connection is also somewhat different. The new valve will not mount in the same spot as the old one. I had to use a piece of 2x4 to move it out from the back of the step compartment so the increased length could be accommodated. The existing hoses were used with no problem and the pipe connections were taken off the old valve and use on the new one. I took the air pressure down to zero on the coach so I wouldn't have any problems. After installing I started the engine and after the air pressure built up I adjusted the pressure regulator until the step closed. This whole process took me several hours but now the step works. Hooray.
Richard,
Job well done.
I had one of the struts that open and close the step fail on me. It was a couple hour project to repair only because the c clamp on the rear bolt was so small and against the wall of the step box. I finally got it on. The moral of the story which was not highlighted in the original post is to make sure you air all the way down prior to removing air operated items or air lines.
RV.net and IRV2 lost a good friend two years ago when his Prevost came down on him...
Yes, I knew Jim. He was going out on a trip and slid under for just a quick check of something or other. Sad
I guess we all need to pay attention here, I also got stuck under my MCI once, I was in my shop, and luck was with me as my employee was there also, I yelled, he quickly connected the shop air line to the air line on the bus, and it filled the system, I crawled out, AMEN etc.!
Dave