I'm considering installing the soap dispenser that came with the Moen faucet. It's about a one inch hole. Is there a special hole saw? I imagine a wood spade bit wouldn't do the trick.
Hi Dave,
A hole saw is the better option. Spade bits are not recommended by Corian. After you bore the hole, sand the edge of the hole, top, and bottom, if possible. Just a slight easing, rounding, of the edge. The sanding stops cracks from developing. Make the bore slightly larger than needed. Corian contracts/expands.
Either a hole saw or spur bit. Tape the area to be cut with painter tape to reduce chipping. Should have no problem.
Cool! Next weeks project along with installing the new Xantrex Panel for the Freedom 25...