Well, my 1994 U300 has been sitting, plugged into 50amp shore power,for about two months, and the engine batteries have lost voltage. The house batteries are fine and charged to 12.65 volts. The engine batteries had dropped to 11.6 volts. The boost switch was in the off position, The master switch next to the entrance door was in the on position. I have been under the impression that while on shore power both house and engine batteries would be charged from the inverter/charger, through the isolator/boost solenoid panel. Any suggestions as to what to look for or check? ???
gerry
I think the manual says that the boost switch should be activated
for 24 hours once a week to keep engine batteries charged.
I use a trik-l-start to keep the engine batteries charged.
My understanding is also that unless you turn the boost switch on or use something like a Trik-l-start, the engine/chassis batteries will not charge on shore power.
Michelle
The default wiring arrangement does not charge the chassis batteries from the inverter/convertor when connected to shore power unless the boost switch is on. We use a 5A Battery Tender to maintain the chassis battery, while the inverter/converter maintains the house batteries. Other folk use Trik-L-Start, manual switches, relays, boost switch, etc., to maintain the chassis batteries while on shore power.
Well I think I learned something today. I must have been using the boost switch in the past and I just forgot that it was needed to charge the engine batteries. Must be a senior moment....... :-[
Jerry, don't feel bad. I have gotten confused about this issue many times. James Trianna confirmed that by factory configuration the starting batteries are not charged unless the boost switch is turned on. Based on that, I purchased an Ultra Trickle Charger and when I went to install it I disconnected the starting battery cables while the coach was on the charger and found that they were hot when disconnected. I haven't found the reason yet but apparently my starting batteries are being charged when on the 110V AC. The isolater and the boost switch both seem to be working properly so I'm guessing there is a hidden trickle charger someplace on board.
I had MOT install a charger to the engine batteries for when we are parked. Nothing else will work except to run the alternator or turn on the boost. There has been varying instruction Kent on how long I could leave the boost on. I think the right answer is for quite some time, but at one time the instructions from a salesman was about 4 hours.
I do like the Eco charger that MOT put on. I hear others use an external charger they simply connect, disconnect. Mine is built into the coach system.
Good luck. Mike
If plugged into external AC power you only need a 3 amp Diode, a 1157 tail light bulb, two pieces of wire about 6" long and a soldering iron. You will also need two terminal to connect to the Isolator.
Poortravel trickle charger.
I will post picture later
I left our boost switch on for weeks. I have seen no ill effects. I did that until I installed a smart charger dedicated to the chassis batteries.
I now only turn on the boost for starting. I have a Battery Tender hooked to the chassis batteries. It is on any time there is 120VAC available at the outlets near the foot of the bed. There appear to be no problems with leaving it hooked up all the time. It charges the chassis batteries with up to 5A. It "floats" the batteries at about 13.32V. That is within 50 mv of the float value on the house batteries, which is provided by the Freedom 25 inverter/converter. I am pleased with this solution to keeping the chassis batteries charged.