Foretravel Owners' Forum

Foretravel Motorhome Forums => Foretravel Tech Talk => Topic started by: geomm on April 15, 2013, 02:34:37 pm

Title: Vacuum pump operation?
Post by: geomm on April 15, 2013, 02:34:37 pm
With either just the key to the on position (not running), or even with the main engine running, I hear a pump running up front for just a few seconds -- and than maybe 10 seconds later it kicks in again.

I found it coming from this pump. Is that normal, to short cycle like this?
I'm assuming it is to supply vacuum for the dash Heat-A/C vent flaps?

 
Title: Re: Vacuum pump operation?
Post by: Gary Bouland (RIP) on April 15, 2013, 02:37:29 pm
Michael, That is the vacuum pump that supplies vacuum to the AC and Heater dash controls.  If it is cycling often there is probably a leak in a vacuum hose.  Close off the outlet and see if it still cycles, it should not.  Then go looking for aged cracked lines to heater AC controls.
Gary B
Title: Re: Vacuum pump operation?
Post by: geomm on April 15, 2013, 02:45:53 pm
Thanks, Gary. Will do.
Title: Re: Vacuum pump operation?
Post by: Pierce & Gaylie Stewart on April 15, 2013, 02:52:08 pm
With either just the key to the on position (not running), or even with the main engine running, I hear a pump running up front for just a few seconds -- and than maybe 10 seconds later it kicks in again.

I found it coming from this pump. Is that normal, to short cycle like this?
I'm assuming it is to supply vacuum for the dash Heat-A/C vent flaps?

 

Our vacuum pump started to cycle on and off. So here is what I came up with.

Yes, it supplies vacuum for vent flaps and the Ford heater/air controls. Your problem is probably in the Ford unit. After spending about an hour troubleshooting, I found the problem in the slider for the temperature. Just move the slider about a quarter inch or so to the right and it should stop the cycling. I posted the cure and found there were a couple of other members with the same symptoms. Heat & Air Vacuum Pump (http://www.foreforums.com/index.php?topic=11971.msg61460#msg61460)

Cure: just keep the slider slightly to the right or use a tiny piece of plastic or what ever to block the last bit of travel. Might superglue it in place. Let us know if this does the trick.

Pierce
Title: Re: Vacuum pump operation?
Post by: geomm on April 15, 2013, 03:41:48 pm
Thanks, Pierce!

This forum Rocks!