My Rear levellor blew an oil seal, on the two round spacers on the side of it,
No Problem, replace seals with newies, Ah, But one of these spacers has been blocked off, no hole in it,
Now, Is this hole supposed to be blocked off or not, It Looks like Araldite in the hole,
Is one of these spacers supposed to be blocked off or not, and if so, Which hole, does the blocked spacer go into,
Which fitting is the inlet and which is the outlet, I didnt check when taking it off,
I had oil running down the road, And stopping the oil running out was a bigger problem at the time,
My manual doesnt give a clear picture of these spacers or O Rings,
Thanks in advance,
They are Automatic Levellors on my Coach,
That is for the kick down cylinder correct? I don,t remember which one is blocked off. There were 2 different types used. One was for manual jacks and the other was for automatic jacks. I guess you could take the other one apart and see where the blocked one goes. I know not much help. If I was home I have a whole library full of hwh manuals
Well I took the other levellor off, The blocked hole is the bottom one,
All new O rings fitted, So it should work now,
Thanks, Red Tractor,
Here you go, Brian.
HWH Service Manuals (http://www.hwhcorp.com/service34.html)
For future reference.
Keith
Thanks for that, I will see if the levellors work today, I have them all back in,