I hate towing a car. Fact is, a decent two up bike would do the job handily, probably an adventure style 1000 cc, somewhat under 600 lbs. I'd prefer to tow nothing, and am trying to figure if it would be possible to use a frame mount carrier. Have looked at swivel wheel trailers but am unconvinced. Front mount, I'd rather not.
I see most folks say this is too much weight on the rear but I wonder if this might be somewhat mitigated by the fact that the U295 has a lighter 8.3 engine compared to the ISL, ISM mounted on same chassis?
No it will not be mitigated as they used a lower rated axle.
If your tongue weight on the hitch allows it. My brother bought a hitch mount M/C rack and puts a Honda CB550 on it and hauls it behind his 35 ft. Holliday Rambler
I have a suzuki dr200s. Light enough at ~300lbs. Im not sure id do 600+ lbs with a hitch mounted carrier. Thats a lot of weight really far aft.
How about something like this? Only downside I see is possible wear on the rear wheel bearings and shocks.
Trailer Hitch Mounted Motorcycle Carrier with Jack and Swivel for 2" Trailer... (http://www.etrailer.com/Hitch-Cargo-Carrier/Oldenkamp/RHMC1SV.html)
I carried a motorcycle on the back of my fifth wheel on a swivel wheel trailer for two or three years. The only real problem I had were blowouts on the single tire. Solved that by going away from Carlisle tires after that no problem. The tire was rated at 1000lbs and we had a Honda VTX 1300 with no problems AFTER going away fro Carlisle tires.
Roland
Used that basic design for years, but mine was stationary with a little ramp to get the front tire in. Used some old flat stock and welded it together.
If you do have to back up a little, you can just move the back of the bike in the direction you want to go, and back.
Most bikes are completely disconnected from the transmission and motor in neutral, so just need to shift to neutral after securing the front wheel. Very little weight on the receiver.
Thanks for the thoughts and suggestions, while I can see the one wheel down style towing working well, the co$t of motorcycle tires and wear and tear on rear suspension of bike rules it out for me. Plus every pothole I straddle is going to be taken by a center wheel.
The question left unanswered, though, is why not just carry the bike on a carrier well mounted to receiver structure? What is the negative effect of this, I'm a long way from the rear axle capacity. Assuming coach is level the effect on front steer tires would "seem" to be miniscule. Moment arms such as figuring weight and balance for an aircraft don't seem to apply when the coach is sitting on wheels (as opposed to a wing.)
Who says this? Can you reference any actual warnings or reputable sources? I'm asking because I see rear mounted motorcycles on coaches going down the road all the time, many of which have a LOT LESS sturdy construction than a Foretravel. I'm just wondering what the actual problem is with this technique, and what factors must be considered?
If you are worried about overloading the hitch receiver, you could always move up to a hydraulic lift carrier, which attaches to the frame. I have seen several of these mounted on Foretravel coaches in the FOT parking lot.
Hydralift Class A Motorhome Motorcycle Lift - Kar Kaddy & Tow Dollies - Tow... (http://www.dyersonline.com/hydralift-class-a-motorhome-motorcycle-lift.html?utm_medium=shoppingengine&utm_source=googlebase&gclid=CJH7gqDU1skCFY08gQodHk0NEw)
Weight of the motorcycle and lift do need to be considered. And, placing that weight 10' or so behind the rear axle will put well more than that weight on the rear axle and remove weight from the front axle.
Here is one of the many website with the formula: Suitability, CruiserLift (http://www.sportslift.com/crsfit.html)
The FACTS determined by working the formula are a lot better than a lot of speculation.
Here is Blue Ox instruction page, with their way to figure the loads imposed by a rear bike carrier.
http://www.americanrvcompany.com/assets/images/BlueOx/LiftAndCarrierInstallationWithRearAxleWeightCalculation.pdf
When I added a lift carrier, I had two 2" receivers added to my frame. I had seen a number of Foretravels with them, and it was an easy add. There was plenty of rear steel to weld to, per the welder I used. I only had one round trip with the lift, bike and towing a car. We found our present coach on that first trip, and bought this one, and sold the older one, the bike and the lift.
Oh do I miss having a bike, as these last two months we have been surrounded by winter Texans with bikes. They ride nearly every day, all winter here in the TX Hill Country.
Yes! Thanks Chuck, Brad and Dave for the objective info. Just what I was looking for.
Just because a lift is made to mount on the back of a coach or fifth wheel does not mean that the coach or fifth wheel chassis is manufactured taking that configuration in mind. And as to what people do? Well that's a whole other story isn't it?
When we had a fifth wheel I considered a lift on the back for a motorcycle. The factory sold them. However when I inquired with the sales manager he recommended against it, go figure. Reason I went with a swivel wheel
Roland
Physics (actually statics) is the same weather it's a wing or tires. When you add weight that far back behind the rear axle, you are not only adding the weight of the load, but you are also removing weight from the front axle. Depending on the length of your RV and front loading, this may affect drivability.
My 34' drives much nicer with a full tank of fuel in it. Also, I put my husky 400 on a harbor freight carrier and I can tell when it is back there. I do need to rebuild the steering box though as it has play.
Our rear engine diesel pusher are butt heavy as it is. Adding 600lbs that far behind the rear axle creates quite the moment...and it shifts the center of gravity further back.
The older FTs had receivers up front.. ive seen a few pics of them. why not build your own motorcycle carrier for the front? the GV style have such high windshields that it wouldnt affect visibility at all.. and on mine at least, I have a massive safety margin on the front axle weight compared to the rear axle. a little bit of fabrication would give you a nice carrier.. not like your motorcycle would block the radiator. Would maybe block headlights at night.. probably wouldnt work so well on a flat front, but its an idea.