As some of you may know? I have vision issues.. it's difficult for me to see if there is shade on the curb side mirror
TEMPLATE MADE-ALWAYS ON
10"rear
7"sides
Using the audit for the front wide angle
I ordered a 360 degree system with a 12" monitor.. an upgrade from the cams I did on the 88, from Tadi brothers... very fast.. helpful..good knowledge.. BUT
No matter how I tried with my vision it wouldn't work BUT SET UP THE SYSTEM... IT WAS FANTASTIC, but the monitor was too big and too far away.. wish it would work.. 1 cb, no wireless.. tadi set up an install for 250...so 1.25 cb
I have difficulty in back-light conditions.. so under the nice 10" wide view-rear I put in LEDS that come on with the ignition..
ALSO new LED DRIVING LIGHTS..
HERE IS THE COMPLETED TEMPLATE... AND READY FOR THE TEST DRIVE.. I SIT HIGH ENOUGH TO SEE 4 FT in front, plus convex mirror.. Thinking about putting another cam in front and use old audit monitor
Almost looks like the "glass cockpit" in some of the fancy new GA planes. All you need is one more LED screen (below the middle screen) with all your dash instruments displayed in digital format.
;D I wish... no digital from mechanical engine... the silver knows on both sides of dash are because if the leds...
One is missing to the right, a 8" gps...also on the left is boost-pyromiter stacked... and planned an old cell phone with altimeter-speedometer
How did you mount the cameras on the side?
Right in the fiberglass on the bumper
This looks amazing! I'd mush rather have my screen there. It would allow you to keep your eyes on the road when changing lanes as opposed to scanning right and down a bit at the stock monitor