Behind the water manifold on the passengers side I have a harness that is sitting there with 4 wires that are cut.. not sure what they go to as I can not tell where they go.. wondering if this rings a bell to someone and to help my curiosity.. thanks
any ideas?
Year and model of coach if you expect replies.
Also, they should have wire id numbers printed on the insulation. You can then check your wiring drawings.
Rich
Sorry i thought I filled the model and year out.. guess I didnt.. 2002 U320.. I didnt see any writing on them but maybe didnt look far enough into the loom
I think FT put all wires in all coaches and then used what was needed for each model. Wires that I use in that bay that you might not with a U320 or that may have been disconnected after the function was upgraded or removed.
Propane/electric water heater controls
Audit Tank sensors
remote valve controls
water pump
compartment lights
compartment heater fan/thermostat
It may make a difference what U320 you have. Someone may have more info if they have a coach like yours. The wet bays can be laid out very differently.
Rich
I have been reading on the topics of the wet bay and some are very different..I need to pull that area apart and check the audit sensors as I am not getting anything from them but I seen they are connected on the black and the fresh water.. The valves and couple water leaks need fixed so I will investigate a little more this weekend.. thanks