There are very few if any 10% or greater performance improvements for our coaches whether it be fuel mileage, or HP due to one component. So who cares? That being said, that's where motorheads come into play. After all is said and done they do exist even on a properly maintained coach. Anybody that's been involved in competitive events knows that 10 1% changes are just as good as 1 10% improvement. It's in small increments which may add up to 10 % or greater. Synthetic oil, improved exhaust, improved intake, lower intake air temps, better aerodynamics, lighter loads, etc. 1.1% increase for every 10 degrees on the intake side gets pretty good results if your sucking in 150 degree Engine compartment air. Bonus is less stress while driving due to being be able to blend with traffic.
"1.1% increase for every 10 degrees on the intake side gets pretty good results if your sucking in 150 degree Engine compartment air. Bonus is less stress while driving due to being be able to blend with traffic".
More...Like Quote
A common mod of the wanderlodge 3208NA owners was to run dryer vent piping from air cleaner intake, [located in doghouse] to area in front of wheel, to lower intake air temps. Does your coach not have an intercooler, in front of radiator?
Anytime you use "road" air for the engine intake, you are reducing the air cleaners's life as well as possibly reducing the life of the engine. Foretravel did just that on many U280/300s with the air intake right behind the rear wheels. The front wheels will already send a lot of dirt toward the back and the engine certainly does not need more. They finally fixed it in late 93 by running an intake pipe across the bottom of the radiator and up to a point several feet off the ground. The later coaches finally got the right idea by locating the intake up high like a lot of coaches have done in Baja. Our air cleaner is expensive and gets choked by road debris pretty fast, especially if driving much on gravel roads. Rodents also take as much as they can into the canister. Quite right in not wanting to use engine compartment air as it's both hot and dirty. Pierce
Pierce, in the Wanderlodge modification, the air actually comes in from from openings around the side of the radiator and the right headlight, and not the road. The 3208NA was only found in the front engine wanderlodges, very different from rear engine Foretravels.
Timely comments as yesterday I did the "unspeakable" thing and took out my air filter as I put it in around Sept 2014 and wanted to see how it was doing. About a 1/2 eggcup full of dirt in can and filter was mid grey colour. Carefully cleaned can with wet rag and ends of filter then put it back, will last a few more years I am sure. Deflector is doing it's job keeping things clean and dry, so all is good.
JohnH
One of the one percents may be the use of the upgrade Donaldson Blu-tech foam air filter.
More power. Better filtering. Double the service life
Interesting info on how a filter does a better job with "dust caking".
http://www.foreforums.com/MGalleryItem.php?id=3416
But when the restriction gauge is at the end and it's lacking a little power, what good is the "dust caking?" Checking the restriction gauge is something that should be done every time you check the oil. The reading will go up a little when driving in the rain. Each manufacturer has a max restriction so it pays to see what yours is. Our Detroit picked up some HP that you could feel after the filter replacement. I've posted the max restriction for each engine several times so it should be in the archives.
Pierce
I don't know, just thought it was interesting. Article was written by Phil Blackburn, a contributor to Motorcader magazine.
If you go to forum home page, click community, then wiki. Lot of good info there.
This applies to all filters, they don't reach their micron rating until the 2/3 loaded IRC. Health facility's monitor pressure drop also and leave them in as long as possible for infection control. My 11400 rpm bike recommends changing the oil filter at every other oil change only.
Many large engines use a "differential gauge" on oil and fuel filters. Because engine oil or fuel pressure may vary with engine speed, this gauge measures pressure difference between suction and discharge of filter, and will indicate or alarm when difference reaches a preset point, indicating a dirty filter. Of course a normal low pressure switch is also used in case of catastrophic pressure loss.
My air cleaner compartment has air intake grille on the starboard side, but is very poorly isolated (huge 1" gaps) from the hot engine compartment so radiator air probably blows thru it looking for a path out. It also sits above directly above the 800 degree muffler with only a piece of sheet metal separating the compartments. the intake cover on the filter housing is highly restrictive (I am guessing about 3" w.c. loss) but keeps the rodents out. Lots of room for improvement. The good news is my rig came with custom made insulated exhaust system and turbo blankets all the way to the exhaust brake downstream of the turbo. I will install twin 5" resonaters in the spring to replace the huge muffler.