Went out today and came back and hearing the 12 compressor running and was not shutting off. I pulled the fused and am hunting around trying to find a leak, not much luck. What I am hearing is the the solenoid valve cannot tell which one yet hearing a rattle. When I close the valve on the block it stops.. Any ideas where to look?
Time to check your slide seals.
Just checked ......Living room side bladder leaking. A month ago I had MOT replace the bedroom slide bladder when Xtream did some fiberglass delam work the slide...
In Florida now thinking what my options are.....Someone tell me this will get better....
If you have a problem with having too much money, that problem will get better.
Assuming the bladders were the same age, I'm shocked at MOT for not suggesting a replacement of the Living room side at the same time!
As my mobil repairman told me while taking lots of my money to repair our Aqua Hot...." you bought a rich man's toy ". Amen
your year is easy to replace but you will have to get your measurements to HWH and they will have to make one up for you. Your coach slide will push in a couple inches and you can remove and replace the bladder pretty easily.
Pick me if you have too much $$$$$
I can do it.
P.s. charlie, did I run into you at FOT, 1/29 - 1/31?
We had left by then
Just measure the length. FOT had my size in stock for living room - 2003 U320.
Dan, did you save money because FOT could push slide in, and not have to pull it completely out?
I had the living room bladder replaced by Old Town Motorcoach last year but the bladder and other parts came from next door at FOT. OTM did push the slideout room in a few inches. "Normal service" and Slide Bladder replacement, Old Town MotorCoach Nac (http://www.foreforums.com/index.php?topic=30356.msg262431#msg262431)
Four months ago I had the bedroom slideout bladder replaced in Oregon. They preferred to remove the slide to do the job. (In our coach design not much room to push the bedroom slide inward). Replaced bedroom slideout bladder at Oregon MotorCoach (http://www.foreforums.com/index.php?topic=32588.msg292469#msg292469)
Thanks Dan. Think we will miss not having OTM around.
Charlie G.
Where in Florida are you? We might be able to help you.
John M.
Pensacola, Thanks I was able to do a patch for now until I get a appointment to have a new bladder installed... Thanks for your offer.
What kind of patch...........can you elaborate?
The leak in the bladder was dead center bottom by the guide. Was able to clean and use a patch and adhesive as if you where patching a tire tube. Let sit overnight and was able to to cycle and it held. Slide is in now and will stay in until replacement.