Hello Fore Forum Netters,
I am trying to remove the cover to the Intellitec Light Switch Panel ( 10 button model )
and am having no luck and a fear of breaking the cover or the Intellitec Light Switch
Module it's attached to.
Does anyone here on the forum have the trick to remove it? Any info on this would be
greatly appreciated.
Larry
2006 Phenix
Read this in another forum, but have not tried on mine. Might try on the wet bay first incase it does not work.
"The black bezel will come off with a pocket screwdriver. It is held on with 4 detents across the long side, about 1/3 of the way from the end. Both the 4 switch and 6 switch panels have four detents. Slip the pocket screwdriver under one side, 1/3 of way from corner and apply pressure to pop it off. While doing so, grab the opposite side of the bezel and push it toward the screwdriver. Just when you think it will break, it pops up. Then do the second one on the same side 1/3 from the other corner. "
Good Luck
Thanks for the prompt response. The coach is in storage and I will go there
tomorrow and give it a try. I was originally prying at the top and bottom of
the plate but was not making any progress other than getting frustrated.
I was trying to locate a picture of the backside of the black cover plate
to have a better understanding of the connectors that I was dealing with,
but I have had no luck finding any pics.
Thanks again for the information.
larry
I have done it to mine as described. Panel literally pops off.