With my fuel priming issues, I'm looking into replacing the obsolete Winn200200 set up. I've checked the archives and found info that was 4+ years old. I checked several on line sources that said the replacement was 790R30. Two different photos represent this kit and I'd like to know if anyone has experience with it. Also, was the wiring for the fuel pump compatible?
That is the kit that I had installed at the same time my fuel lines were replaced. I do not use the clear plastic bowl, just a solid filter with a drain on it. The electric primer pump is much better than the manual push button I had. Been using this system since 2015.
That is the same filter (the one in the right pic.) we went to when we replaced our Winn200200. When I have time the plan is to install a Davco 382 filter near the rear of the frame rail somewhat near our A/C compressor. Moving to this location will get the filter away from over the batteries and in a place that is simple to service. Don has posted some pics. of this mod. U320 Fuel Shut Off Valve - Location/Installation (http://www.foreforums.com/index.php?topic=33036.msg331566#msg331566)
The Racor filter came with a new pump control panel that all was needed to hook up is your pos. and neg. power supply
Mike
I upgraded to this system with no problems. Posted pics on this forum. Works great, easy install, only minor mod required for the mounting bracket.
Ted, there are two photos. Which one looks like yours?
The one on the right Sven- R90P.