I am looking for the info on my 2002 U320 rear axle seal with tone ring or exciter ring for the ABS .
I had read in another thread that if you replace just the seal you will lose the ABS function.. Earlier I had replaced the leaking seal and also lost the abs function.. I thought maybe we had damaged a sensor or something and hadnt had time to look it over but... I have one side leaking again.. Not sure why but the seal failed and I need to replace it plus my rotor has a crack in it from the heat so..
Anyone have the part numbers so I can track down the parts I need.. thanks
Barry's site had the info or at least part of it but I couldnt find it last week when I looked for it.
And as always thanks for the help
Meritor RS21145NFCF433 Is the axle number
Rear brake rotors 3218K167 Rear ABS SENSOR A2237G1073
Front brake rotors 3218Y1065 Front ABS sensor AL1027194
ABS ASSEMBLIES 427500100-0
Any hel with finding the rotor combo would be great.. maybe I can get a hold of Foretravel.
You might try finditparts they have a lot of Meritor parts in stock. As for seal replacement I have never seen a seal cause a sensor to go bad. Sounds like you may have a sensor on the fritz and possibly not pushed out close enough to the exciter ring on the hub. I as well replaced a wheel seal on the driver side drive axle before out 2400 mile trip due to a leak and I found out why I was getting an intermittent ABS fault code, wires were damaged on wheel sensor and would from time to time short out and cause a fault also was causing a lot of transmission shift problems, after the repair coach has ran better that it ever has since the repair.
Also Fleet Pride has Meritor parts as well that's where I purchased my wheel sensor.