After dismantle of my burner, I replaced the bearings, fuel pump, nozzle etc. but upon further inspection I noticed two frail wires which have brittle insulation and it is cracked exposing the wire core. My intent is to replace the brittle wires and connectors. Does anyone know if these are some type of special high temp wires or connectors that must be used? I looked at the cost of a replacement harness and swallowed pretty hard?
Check with Rudy on this forum!
I did send him a PM. Ty
I replaced those wires and used regular wire if those connectors go to the coil.
Rudy welcomes phone calls between 8a-8p
713-818-3234
Keith