My a/c suddenly quit cooling. I checked and noticed the compressor clutch was not engaging. There is a red and black wire on top of the compressor that disappears behind the pulley. I'm assuming this is a signal wire to engage the clutch. I'm also assuming that this wire is most likely fused. My question is this. Should the red wire have 12 volts? And if it doesn't, does anyone have any idea where I might start looking for a fuse on an 08' Nimbus 342? I'm on the road and like a dummy I left my Foretravel box with all my schematics at home. Thanks.
If you are low on Freon the clutch won't engage.
I hope that's not the case. I had it repaired at MOT June 21 when I bought it. They leaked checked it and found none. I guess anything is possible. I was hoping something simple. 😂
Many AC vehicle systems have a sensor that shuts down the compressor with high engine temps. It could be bad. Possible switch on that allows the blower to circulate air without the compressor being on. Have member with same coach send you the fuse and relay number and location to check.
Pierce
You are in luck. I have just got done working on my dash AC and almost have the schematic memorized. I have it attached. For
the compressor to work the control module sends a ground to the clutch relay and the power relay. When the clutch relay is activated it sends 12 volts back to the engine where there are 2 sensors on the freon line. I believe one is a high limit and the other is a low limit. If all is good then 12v is sent to the compressor.
First test is to take a test light and see if you have 12v at the compressor. If no 12 V then look for the two sensors that are attached to the freon lines. If no go there then the problem may be under the dash with the AC control module or a relay.
If one of the sensors on the freon line are open, then either a freon problem or bad sensor
One limit switch (I believe the high pressure) is located near the compressor, the other one on my coach is located near the condenser. When my compressor quit working it only required me to disconnect the sensor wire, clean it and replug it. That saved me replacing a sensor. Hope yours is the same.
Richard
You can hot wire the compressor and check the clutch . The clutch has an air gap that gets larger with age and can be adjusted to function at least once in its life.
After checking the above electrical functions.
Following on from TurboJack clear description, to help diagnose, if a jumper wire on a pressure sensor starts the compressor, you found the cause and the compressor could run for a while to see if cools the dash evaporator.
We built a low-pressure sensor connector with a switch to force compressor to run when adding a refrigerant can sitting in a pan of hot water. But after finding a hose connection leak 7 years ago, we have not added any more refrigerant cans.
BTW, low and high pressure sensor switches can be located anywhere in the engine compartment, usually one on suction hose from condenser coil to compressor and the other on pressure hose out of compressor. I have also seen a single combination high/low pressure sensor.
Axle discussion split from A/C discussion