So I want to top off the fluid (engine oil) in the canister on left of engine but it has a glass sight level.
1. Do I need to have the engine off when I'm pouring the oil in?
2. How do I use the sight level? Is it like an "empty" to "full" range measurement?
3. Is this steering system connected with the actual oil in the engine itself? Or are they two different systems using the same fluid?
Thank you all!
The sight glass is the low mark, use the dipstick attached to the cap with the engine off. Remember just loosen the cap and lift the dipstick out, don't completely unscrew the cap or the dipstick will fall into the tank.
#3. They are 2 different systems both should use the same oil though.
Mike
Yup, it uses the same oil as the engine, but the two system are totally separate.
Easy to verify-- hydraulic oil CLEAR. Engine oil BLACK.
Thank you all for the knowledge and help!
Oh no. I carefully opened the cap on the canister and there was no dipstick. Instead the cap was affixed to a grommet? with a screw (with a pointy end) keeping them together.
Can this canister be overfilled? If I used a ruler and measured in inches from the top of where the cap sits over the canister, how many inches should the oil be from the top?
What should I see in the glass sight? Do I look at it from the side or directly into it as if to look into the canister?
Thank you all
Oil just needs to be in view of the sight glass. Too low and you dont know how low. I can view the sight glass from outside the coach threw the louvers. When the day comes to service the filters inside you may find your dip stick then. Make sure your cap still seals up correctly
Scott
Get a magnet and fish the dipstick out of the canister.
While the dipstick may certainly be in the reservoir, it can NOT be sucked into the pump.
It will have fallen on the outside of the filter stack and be happily "resting" on the bottom.
So, no worries. Just get it out when you next change the filters (doing the change using the correct procedure so you don't mix unfiltered oil with the filtered oil.
Wolfe10 - thank you I was wondering if the dipstick could have made it beyond the reservoir! I just need to put enough oil into it to go 15 miles to the repair shop where they'll pull the steering box and send it for repair.
Thank you all for the information.
Change the filters and top/lid gasket at the same time since the fluid will be drained.
A very easy DIY job.
Sean,
That tank has 3 filters Nelson 84101B (the new Fleetguard #87610A) and you need the gasket for the lid 999-55A
Mike
Be sure the tank is completely drained before removing the wing nut/"washer"/filters.
And, if any debris in the bottom outer area of the tank, clean that up as well.
This way dirt or unfiltered oil will not bypass the filters and be sucked directly into the hydraulic system.
Once you have the lid off, NO tools are needed-- just a wing nut to remove by hand. That is why I said an easy DIY job.