Travel Mode light will not come on, and Silver Leaf is show a Level Warning.
I have it bypassed so I can get into drive and coach is aired up to Travel Mode Height, just can't get the Mode light on the HWH computer.
I've cycled the slides, used the HWH reset button but still not improvement.
Any recomendations for next steps to troubleshoot?
Thanks
I would check the Hobbs pressure switches that are related to the HWH system. Look on the 6 packs for the pressure switch to start with.
Mike
Where are the 6 packs located, and what does the pressure switch look like.
While I don't know your nimbus, your six pack should be located between your front wheels and your back wheels. You'll see them with airline going in and then six airlines coming out. There may be more since you have slides. In order to see it you'll have to get under the coach which means you'll have to be able to air it up and block it.
I'm not familiar with your HWH system as it's much newer than mine on mine the green travel light just means that the pressure has aired up to over 90 lb.
So first find out is your air pressure building up pressure in your tanks? Is your air dryer cycling and purging when it reaches it's cut off?
There's interlocks for slides that will prevent certain things from happening. Again not familiar with your coach but that would be some of the places that I would look at first.
Good luck.
Have you check your fuses. In mine it is a seven amp fuse for the travel mode.
Hwh has two parts, the slides are one part, if the sldes are not in properly the hwh will not go into travel mode, check the fuses and make sure they are fully seated.
The second part is the ride height check the height of all bags to see if they are at the proper height. Hopefully that tells you which system is the problem.