Trying to see if I can fix ABS light always on in my dash. The tag axle sensors were both hanging down and dragging the ground. I have replacements from Foretravel but in chasing the wires down I cannot follow them far enough to find the control box, that is where I assume the other end of these sensor cables end.
2002 U320 with tag, trying to locate the ABS control module, any direction would be appreciated.
In our '03 it was the back wall of the compartment with the HWH controls/compressor
Resetting ABS Brain (https://www.irvblog.com/foretravel%20projects/ABS-Reset/)
There should be a plug not to far from where the sensor is and you can unplug there and plug in the new ones.
The cables are 10-12' long with no end or plug in sight as it snakes up into/over the wet bay and disappears.
Thank you! I will look for the control box there, I appreciate the help. I didn't know what is looks like either so now I have a solid starting point.
Ours is a s Michelle said. Compressor/Inverter bay, far inside wall on upper left.
On my 2000 it is in the front center forward most full compartment on the ceiling near the inverter.
Think I found every hidden box/controller on my coach searching for the Allison ECU(TCU) 🤣
I vaguely recall that's sometimes in the manibloc bay or the LP bay ;)
I did find it after a day of searching - center ceiling of rear most bay (so just ahead of water/magnibloc) - its about as close to the trans as possible... interesting fact, my coach doesn't have a VIM but direct connections to anything it interfaces with and it's own diagnostic port under the dash...I'm going to write this story up.
Look for a silver box that says WABCO on it. You can just see it on the far left of this picture.