HWH DC compressor on older builds

September 06, 2010, 05:17:30 pm

'93 u300
Questions.
#1 Is DC the compressor on this model Just for the leveling?

#2 Most of the time while sitting with the level on, today for 4 days, I never see the air pressure below 100 psi. Is this due to the DC compressor ( which I never hear run)

#3 How would I go about checking/adjusingt the air compressor on this model???

Bill Chaplin "Newbie"

Re: HWH DC compressor on older builds

Reply #1 – September 09, 2010, 03:20:08 pm

Quote

#1 Is DC the compressor on this model Just for the leveling?

Basically it is just to maintain level as initial leveling should be done with the engine running.

Quote

#2 Most of the time while sitting with the level on, today for 4 days, I never see the air pressure below 100 psi. Is this due to the DC compressor ( which I never hear run)

Could be, it can put out 125 psi, but not much volume.

Quote

#3 How would I go about checking/adjusting the air compressor on this model???

There isn't much to check or adjust. With the system on (red light showing) have someone push a raise button while you watch and listen, it should come on. When in auto level if a yellow light comes on the compressor should come on, if the system can not level by releasing air first. After 30 min if level is not achieved the pump should stop and will not run again until a new leveling sequence is initiated.

Not sure if we have the same system as we have different models. Barry Beam has a HWH manual posted on his website.
http://www.beamalarm.com/foretravel-links/PDF/hwh-manual-ml31043.pdf

Foretravel Owners' Forum For owners and Fans of Foretravel Motorcoaches September 09, 2025 ...