Skip to main content ↑ ↓
Topic: Winn Fuel Filter Gizmo (Read 1362 times) previous topic - next topic

Winn Fuel Filter Gizmo

I've been reading the thread on the fuel-water filter setup on the 90s models. Our 95 300 has an M11 and this is the setup. Would this be the original? When I bought this rig it was bypassed. I had the Cummins guys look at it, replace the filters and hook it back up. They advised me that I was good to go, however, after reading that thread I'm wondering if I can look forward to air in the fuel through the pesky o-rings. Advice? Thanks.
jor
93 225
95 300
97 270
99 320

Re: Winn Fuel Filter Gizmo

Reply #1 –
Yes, that is the original set-up.  Yes, it's important to keep the o-rings on hand and replace regularly.
Regards,
Brett

'99 42' Foretravel Xtreme
'14 Brown Motorsports Stacker
'05 Chevy SSR
'02 BMW R1150R

Re: Winn Fuel Filter Gizmo

Reply #2 –
It looks different than the set-up on my 95 U320.
It looks like you have the upgraded fuel filter housing and fuel filter and the original Winn filter.

My original fuel filter has electrical wires running to the filter itself.
I ordered the "newer" conversion housing and a new Winn housing and filter.
It was when I went to install it that I saw that the whole unit had been bypassed just like your unit was.

Have you experienced any problems since you had it re connected?
How long has it been since it was reactivated?
1995 U320C SE 40'
Jeep 4x4 Commander - Limited - Hemi
"The Pack"  Yogi and Diesel our Airedales -  Charlie our Boxer/Akita mix. Gone but NEVER forgotten Jake our yellow Lab.
NRA Law Enforcement Firearms instructor - Handgun/shotgun
Regional Firearms instructor for national Armored Transp. Co.

Re: Winn Fuel Filter Gizmo

Reply #3 –
Quote
Have you experienced any problems since you had it re connected?
How long has it been since it was reactivated?
Just had the service done locally and drove it home. Haven't gone anywhere yet. We're leaving in a week or so for Nacogdoches and then on to Oregon. I think for now I'll pick up a nipple to take along so I can bypass it if need be. Guess I should replace the plastic bowl. Thanks.
jor
93 225
95 300
97 270
99 320

Re: Winn Fuel Filter Gizmo

Reply #4 –
That looks very similar to the original on my 1996 U320.
My Winn purge pump on mine was seized, so I replaced it with a Racor which has a clear water bowl on the bottom.

The Winn is a good system because you can see air or junk in the plastic "see through" container. If your M11 becomes hard to start, and you can see air in that see through container, air is getting by the "O" rings. Confirm that your purge pump still works before doing anything else to extend the life of this system.

The Winn air leak problem may not be fixed by replacing the "O" rings. The plastic necks at the top and bottom become smaller diameter where the "O" rings squeeze. Remove the see through container and look at the top/bottom necks.
It is not difficult to remove this "see through" container. There is a thumb screw at the top holding the top fitting down. Remove this thumb screw and push the top fitting up, then pull the see through container up and out of the bottom fitting. I pressed short pieces of copper tubing into the top/bottom necks on mine for a permanent fix. I had to make these short pieces of copper tubing the correct diameter by compressing tubing which was slightly too large.

I believe that those Winn "see through" containers are no longer available, perhaps someone else on Foreforums and confirm.
Wyatt
96 U320 40 WTFE, build 4943
84 Toyota Supra towd
2015 Jeep Wrangler towd
Victoria, BC, Canada

Re: Winn Fuel Filter Gizmo

Reply #5 –
The plastic filters are supposed to still be available as racor 300200 filters. I have 2 on order from central diesel in Virginia and talked to them today and shoud have them in a week
previous 1984 35 ft ORED 250 HP 3208 Cat       
previous 1998 40 ft U295 CAI 325 hp Cummins
previous 2003 40 Ft u320 build #6140 450 Cummins M11.                                                         
1999 Mazda Miata
Ron, Nancy, Tipper the cat, Max The dog
1997 U 270 36 ft build number 5174 8.3 Cummins

Re: Winn Fuel Filter Gizmo

Reply #6 –
I tried to acquire one  in Las Cruces in Feb. - was told "No Longer Available".  Please advise when you receive them and where you placed the order.  I would like to have a spare.  Thanks.  :)
Scott & Carol Seibert
2001 42' double slide U320 - Sold
Previous - 2002 36' U320

Re: Winn Fuel Filter Gizmo

Reply #7 –
Here is a picture of the unit on my 95 U320.
I bought a conversion Racor # 12963 so that I can now us a Racor/Parker S3230P fuel filter. I bought this from Diesel Filters.com. for $83.16.

I originally ordered the WINN 300200 filter from Diesel Filters. They called and said they no longer could get the filter but could order it for me from Parker/Racor direct. I believe the price was around $30.
Racor/Parker is in Beaufort, SC 843-846-3200

It looks like you already have the updated fuel filter housing.

Wyatt, Now that I'm looking at the WINN 300200 and the new plastic housing (here on my table), I see how your copper tube suggestion works. I will definitely do this modification, THANKS!

I will try and install all this stuff this weekend an see if it works.
I will take your lead in having a fitting so I can bypass the unit if it gives me trouble.
I will also keep my eyes open for a new water separator/filter system to replace this system in the future.
1995 U320C SE 40'
Jeep 4x4 Commander - Limited - Hemi
"The Pack"  Yogi and Diesel our Airedales -  Charlie our Boxer/Akita mix. Gone but NEVER forgotten Jake our yellow Lab.
NRA Law Enforcement Firearms instructor - Handgun/shotgun
Regional Firearms instructor for national Armored Transp. Co.

Re: Winn Fuel Filter Gizmo

Reply #8 –
Posted before that you can simplify your Winn/Racor parts issue by simply contacting
Central Diesel, Richmond, Va 
800 598 9814  OR  804 275 3900
Ask for Dana, he has been my go to for many years.
Others have gone ahead of you from this forum, none have attacked me yet for recommending this outfit.
FWIW

Re: Winn Fuel Filter Gizmo

Reply #9 –
I am planning on replacing the system on my coach with a  Racor 700 series unit. The 790R30 looks like a good choice to me, the same basic system without the "O" ring issues. Does anyone have any experience with this system?
2002 U320 40Ft  MC # 15759
Coach # 5995
Previous coaches
2002 U320 coach  #5941
1996 U270 coach #4808

Re: Winn Fuel Filter Gizmo

Reply #10 –
Quote from: Dave M –
Posted before that you can simplify your Winn/Racor parts issue by simply contacting
Central Diesel, Richmond, Va 
800 598 9814  OR  804 275 3900
Ask for Dana, he has been my go to for many years.
Others have gone ahead of you from this forum, none have attacked me yet for recommending this outfit.
FWIW


Recently, I used the information that Dave M provided and ordered/received two of the filters.  Dana is very professional and easy to work with.

Good Luck, Dave A
Dave and Nancy Abel
'00 U320 36' WTFE  Build #5669
'10 Jeep Wrangler Unlimited Rubicon
Livingston, TX  SKP's Fulltiming

Re: Winn Fuel Filter Gizmo

Reply #11 –
Someone here fitted that system within the last year or two and was very satisfied. You should be able to find the thread with a search. The shop doing the work tied the old control switches in also. I can't remember if there was also a relocation for better access.
The selected media item is not currently available. Dave Head & Megan Westbrook
Titusville, FL - The Great Outdoors
'98 270 buying this month
Toad is a 2018 F150 XLT
 

Re: Winn Fuel Filter Gizmo

Reply #12 –
RV Chassis Parts or Oregon Fuel Injection has the clear filters. Those buggers are getting harder to find.
I ordered from Oregon Fuel Injection and they were on back order for months. Got a call yesterday that they're in.

I had already ordered from RVCHASSISPARTS and got them in short order so I canceled the order from Oregon Fuel Injection.

I've experienced the air leak issue at the o-rings. I now coat the o-rings with DOW High Vacuum grease, a silicone grease, and make sure the thumbscrew that holds the assembly together is tight, with an adjustable wrench,  and have not had a problem since. I can't tighten it enough by had to assure no leak.

Several years ago the controller for the Racor went out so it would no long purge, the controller (black thing with buttons) is no longer available. Big problem if you need to change a filter, diesel systems abhor air in the fuel system. I figured out which wire ran the pump and mounted a push button, wired it up and now the pump runs as long as I hold the button down. I don't care anything about the water in fuel indicator light.
I wouldn't mind replacing the whole thing but it's working great and there's too many other things to spend money on.
David Bethard
2003 U320 - 40ft. Build #6159
ISM 500hp
2006 Jeep Liberty CRD
2021 Honda Goldwing DCT