Skip to main content ↑ ↓
Topic: Meritor Rear Rotor Part Numbers (Read 1440 times) previous topic - next topic

Re: Meritor Rear Rotor Part Numbers

Reply #25 –
Can somebody please post the Part Number for the "helper springs" that go on the slide pins?

Also, I found this post on another forum that lists many different PN including sets of pads from other vendors (post 4) RV Service Center in Atlanta?? - iRV2 Forums

1998 U270 34'

Re: Meritor Rear Rotor Part Numbers

Reply #26 –
Quote from: krush –
Can somebody please post the Part Number for the "helper springs" that go on the slide pins?

Searching the forum for Meritor helper springs brings up KIT15018

Helper springs on Meritor disc brakes

We bought ours from FindItParts, here's the link to the springs KIT15018 by MERITOR - KIT
Learn every day, but especially from the experiences of others. It's cheaper!  - John C. Bogle

2000 U320 36' non-slide / WildEBeest Rescue
2003 U320

Re: Meritor Rear Rotor Part Numbers

Reply #27 –
You can get them through NAPA, though they might have to order them in.
1996 U270
Build #4846

Re: Meritor Rear Rotor Part Numbers

Reply #29 –
Adding a couple of pictures of the disfigured rear pads. 

I forgot to take pictures of the removed caliper before I got it all cleaned up.  The iron/rust on the caliper from the outer pad had to be removed with a grinder and a wire wheel.  What a mess.

Question for anyone who has replaced the pads- the inner pad (the one that moves) seems to travel just fine when the caliper moves but on the return, it gets a little cockeyed and the top of the pad doesn't seem to always return fully to the caliper though the bottom does.  Does this just need to filed and sanded down a bit more?


Robert
Build # 5304
1998 34' U270 Cummins 6CTA8.3

Re: Meritor Rear Rotor Part Numbers

Reply #30 –
Meritor has definitely limits on the amount of slide pin/bushings wear.  You maybe need to check on that.
1996 U270
Build #4846
 

Re: Meritor Rear Rotor Part Numbers

Reply #31 –
Gayland,

This is with the caliper completely removed and sitting on a workbench.  I'll probably just file it down a bit before I reassemble everything and see if I can get it moving smoother. 
Robert
Build # 5304
1998 34' U270 Cummins 6CTA8.3