Skip to main content ↑ ↓
Topic: SeeLevel Instalation on Fresh Water Tank (Read 1176 times) previous topic - next topic

Re: SeeLevel Instalation on Fresh Water Tank

Reply #25 –
Old Tape: Mine came off easily. Just cleaned up the residue and installed the SeeLevel strips in about the same location.
Old Wiring: I did as Roger suggests; just cut and capped them and ran new wire.
Hose Connection: I've never see that. Must be some kind of cleanout, I guess.

There are some great threads with photos on SeeLevel installations. Here's a few photos of the install on our present coach which is a 95. Like yours, it has a water heater. I didn't have to remove it, however, in that there is an access hole from the adjacent compartment. I installed the bottom strip by reaching under the heater and the top one by reaching through the access hole. You have to work more or less blind. A little unnerving as those SeeLevel strips really stick when they contact that tank.

As others have done, I mounted one monitor inside and one in the wet bay. I think you will really like your SeeLevel system.
jor
93 225
95 300
97 270
99 320

Re: SeeLevel Instalation on Fresh Water Tank

Reply #26 –
Jor,
 
Wow! So much information from all those pictures.
 
First, kudos for having such a clean basement. How did you get it so clean, let alone keep it clean?
 
How do you have such an impressive looking output device for your water heater? Mine has all kinds of rust on it, including many rust flakes on the floor under it. Is yours a replacement; where did you get it? Speaking of impressive looking, what the heck did you use on that faucet? I am sure mine did not look that good when it was new!
 
What are the two meters (?) to the left of your cable input? What are the two black hangers on the left wall? What is the blue material you have on the floor of the water bay?
 
I saw that access hole at the back of the fresh water tank, but i cannot imagine how to properly apply sticky tape in the right position from there; kudos again!
 
Keep up the good work!
 
Thanks,
 
Trent

Trent and Jean Eyler
2000  U295  4003  WTFE  ISC  350
Build#5603 MC#17385
 

Re: SeeLevel Instalation on Fresh Water Tank

Reply #27 –
Quote
How do you have such an impressive looking output device for your water heater?

Not sure what you mean. I replaced my water heater so it's nice and shiny. The old one was absolutely choked with calcium deposits. It's a direct replacement. Atwood GCH10A-4E 3 Way

Quote
what the heck did you use on that faucet?
Just the stock faucet.
 
Quote
What are the two meters (?) to the left of your cable input?
Progressive Industries EMS. One is the selector for cabin monitor or wet bay monitor and the other is the actual monitor.
 
Quote
What are the two black hangers on the left wall?
Just a couple of hooks for rags.

Quote
What is the blue material you have on the floor of the water bay?
Some kind of rubber shelf liner material. I just cut it to fit and lay it in place (no adhesive)

Quote
i cannot imagine how to properly apply sticky tape in the right position from there
You can do it! Beats taking out that darn water heater.
 jor
93 225
95 300
97 270
99 320