Skip to main content
Topic: Air Leak (Read 373 times) previous topic - next topic

Air Leak

Here's where I found a major air leak. Might be worth checking if you have a similar setup.  The air line ran from the wet tank to an air hose fitting in the water manifold compartment. The line passed through a rough hole in the compartment wall with only silicone protecting it. Should have had a grommet. Probably been leaking for years. It was close to letting go completely. I eliminated the line altogether as I have never had much use for those external air connections. Takes a day and a half to air up a low tire!
jor

93 225
95 300
97 270
99 320


Re: Air Leak

Reply #2
Surprised you didn't have problems reaching "unload" pressure in your wet tank.  Was your air compressor cycling on and off at a rapid interval, compared to your experience with your previous coaches?

You can speed up filling tires (with on-board air system) by setting your D2 governor up a bit.  I have ours set to kick off at 130 psi, and it kicks on at around 105 psi.  I run 100 psi in our tires, so I can top them off pretty quickly with the coach air hose.
1993 U280 SE 40' WTBI, Build: 4359
C8.3 300hp, 6-Speed, Exhaust Brake
960 watts on the roof (6 x 160)
Sorento (or BOLT) on a Kar Kaddy SS
"Nature abhors a vacuum"

Re: Air Leak

Reply #3
Chuck,
I thought the same thing, the hose must have had a one way check valve at the wet tank.
Larry
Larry and Terry
Ex 2004 U270 36'

 

Re: Air Leak

Reply #4
Quote
Was your air compressor cycling on and off at a rapid interval, compared to your experience with your previous coaches?
About the same as the others. This leak may have become worse with all of the up and down and twisting I've been doing. I hadn't noticed it before today but then I've only had this thing a few weeks. No check valve; just a straight line from the tank. This coach has two of those air fittings, one on each side along with the wet tank dump valve. I'm leaving the other air connection for towing.
jor
93 225
95 300
97 270
99 320