Skip to main content ↑ ↓
Topic: Generator bay problem (Read 559 times) previous topic - next topic

Generator bay problem

Hi all,

Can't get my generator door (2002 u320) to release. 3 of the electric latches work fine but one (a top one) wont let go. I can feel the switch being activated and I can move it. 

The next thing I was going to try was removing the complete latch assembly. 

Anyone have another suggestions ?

as always,

much appreciated

We are only strangers until we meet; however, some of us are stranger than others

Re: Generator bay problem

Reply #1 –
Try pushing in on the door corner while pushing the release button, to take the strain off the bear jaw latch.  Others have had good luck popping the corner with their fist.

Re: Generator bay problem

Reply #2 –
If you can reach it from below with something the latch should release by pushing UP on the cable. Clean and lube .
Dick
Dick, '03 U320 40' Tag, 2 slides, Coach #6075
Full Timers
2009 Honda CR-V

Re: Generator bay problem

Reply #3 –
Got it opened by removing a bolt and loosening the other on the latch. Not sure what caused the jam but it was difficult getting it opened even with the latch released.

Going to give her a greasing and adjust cables.
Thanks ll

We are only strangers until we meet; however, some of us are stranger than others
 

Re: Generator bay problem

Reply #4 –
Try a spray on dry Teflon lubricant, works great and dust and grit don't adhere to it.
Old Phart Phred, EIEIO
89 GV ored 36' #3405 300 hp cat 3208 ATAAC side radiator, mountain tamer exhaust brake