Skip to main content ↑ ↓
Topic: How to slide out powertech generator on an o2 u320 (Read 1045 times) previous topic - next topic

How to slide out powertech generator on an o2 u320

Need the how to slide generator out and where is the chassis kill switch?

Re: How to slide out powertech generator on an o2 u320

Reply #1 –
terry1950,
On my 2001 there is a bolt near the front of slide on each side of the bottom of the generator tray.  You need to disconnect the exhaust pipe as well.  I am not sure what the chassis kill switch is.

Roger
Roger Engdahl and Susan Green
2001 U320 3610 #5879 (Home2) - 2014 Jeep Cherokee or 2018 F150
Hastings, MN

Re: How to slide out powertech generator on an o2 u320

Reply #2 –
They used a forklift to slide mine out.
Tom Lang K6PG (originally  KC6UEC)
and Diane Lang
2003 38 U295 build 6209
2016 Jeep Grand Cherokee Summit Ecodiesel
still have tow-ready 2006 Acura MDX 
Temple City, California
Motorcade 16681 California Chapter President
SKP 16663 member of SKP Park of the Sierra, Coarsegold California
FMCA F071251
Retired electrical and electronic engineer

Re: How to slide out powertech generator on an o2 u320

Reply #3 –
How far out do you need to get it? 
If only enough to do oil change/service pulling the 2 bolts like Roger said should do it.
On my 1999 I had to disconnect & plug the fuel line to pull it farther out to access the control box.  There is also a heavy rubber mat on the bottom that can be unbolted and removed to access the rear of the generator.  I did not have to unbolt the exhaust on mine to pull it out the additional 8" or so.
Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
no longer 1999 36' U320 build #5522
2013 Rzr 570 & 2018 Ranger XP1000
2006 Lexus GX470
2011 Tahoe LT 4x4
Previous 1998 45' 2 slide Newell, 1993 39' Newell

Re: How to slide out powertech generator on an o2 u320

Reply #4 –
The quiet box generator does not have the rubber mat at the bottom and you have to unbolt the exhaust to pull it out very far.
previous 1984 35 ft ORED 250 HP 3208 Cat       
previous 1998 40 ft U295 CAI 325 hp Cummins
previous 2003 40 Ft u320 build #6140 450 Cummins M11.                                                         
1999 Mazda Miata
Ron, Nancy, Tipper the cat, Max The dog
1997 U 270 36 ft build number 5174 8.3 Cummins
 

Re: How to slide out powertech generator on an o2 u320

Reply #5 –
On my 2001 I can do all of the service without moving the generator at all.  Probably the same on a 2002.  If you have to remove the generator completely then you will need some heavy lifting device (fork lift would be nice or a pallet jack)
Roger Engdahl and Susan Green
2001 U320 3610 #5879 (Home2) - 2014 Jeep Cherokee or 2018 F150
Hastings, MN