Skip to main content ↑ ↓
Topic: Alternate steering box to replace the M100PDP1 (Read 2994 times) previous topic - next topic

Re: Alternate steering box to replace the M100PDP1

Reply #25 –
Tell them to build it the wAy it came in.
The selected media item is not currently available. Dave Head & Megan Westbrook
Titusville, FL - The Great Outdoors
'98 270 buying this month
Toad is a 2018 F150 XLT

Re: Alternate steering box to replace the M100PDP1

Reply #26 –
The alternate box that is being talked about is also used in a 2000 Kenworth.
The selected media item is not currently available.Bill&Doris 97 U270 36'
University of Parris Island Class of 66
Semper Fi  Build# 5174 MC#17094

Re: Alternate steering box to replace the M100PDP1

Reply #28 –
I am going to get to this soon I hope..

If I send in my steering box to redhead will I still need to worry about stops or adjusting them? Or is that only with a new box that did not come out of my Coach?

Re: Alternate steering box to replace the M100PDP1

Reply #29 –
Quote from: DavidS –
I am going to get to this soon I hope..

If I send in my steering box to redhead will I still need to worry about stops or adjusting them? Or is that only with a new box that did not come out of my Coach?
David,
  If I remember correctly when I talked with readhead on the phone while mine was being done, they said they did not mess with the stops during rebuild. You could call them to verify that.
Mark
The selected media item is not currently available.
Mark and Tanya
Milton , Florida
US Navy Veteran (DV)
1999 U270 Special 40' CAI , 2015 Jeep Wrangler Sahara

Re: Alternate steering box to replace the M100PDP1

Reply #30 –
David,

I would always check stops-- certainly of steering box has been overhauled.  Agreed, they MAY NOT have been adjusted, but 5 minutes under the coach will VERIFY.

Do not assume that it is even optimized (max cut angle) from the factory.
Brett Wolfe
EX: 1993 U240
Moderator, ForeForum 2001-
Moderator Diesel RV Club 2002-
Moderator, FMCA Forum 2009-2020
Chairman FMCA Technical Advisory Committee 2011-2020

Re: Alternate steering box to replace the M100PDP1

Reply #31 –
David, I had my steering gear rebuilt by Redhead two months ago. I asked the same question and they said it would be returned with the same adjustments that it came to them with.

After I reinstalled it and checked the stops, I found that the drivers side was perfect. The passenger side needed a lot of adjustment to get it to stop before hitting.

Unfortunately, I never thought to check the stops before removing it and sending it in to be rebuilt. So I don't know if it was not adjusted properly before I removed it.

Compared to the rest of the job, adjusting the stops is really easy.
2003 GV320 4010
 

Re: Alternate steering box to replace the M100PDP1

Reply #32 –
I am getting ready to install a new steering box from r h Sheppard  m100pdp1  any tricks on bleeding the lines? there is just enough room to get the pitman arm off I think. I have the low profile puller. my coach is a 2003 gv320 . Also any ideas on getting the box in and out other than the floor jack ? any help will be appreciated.
Thanks, Karl