Skip to main content
Topic: Running cable from back to front (Read 789 times) previous topic - next topic

Running cable from back to front

I need to run a cable from the back cabinet (the one above the end of the bed) to the dashboard (video camera).  I've been told that there is a "duct" of sorts that runs length of the coach, but I don't know how to access it.  See the attached drawing and a photo of the area in my coach.  I could also use some advice on pulling the cable through. 

Thanks in advance,

George
The selected media item is not currently available.
George Hatfield

  Never ever use World Line Motors of Nacogdoches for service!

Re: Running cable from back to front

Reply #1
See Cable routing to rear monitor
Roger Engdahl and Susan Green
2001 U320 3610 #5879 (Home2) - 2014 Jeep Cherokee or 2018 F150
Hastings, MN

Re: Running cable from back to front

Reply #2
George,

Just run a fish through that upper beam.

I did have one person tell me that there was an obstruction that did not allow it, but most are able to use it. 

On older models, you can also pry out the little "breathable" plastic plugs in the overhead cabinets to help move the fish along.

Brett Wolfe
EX: 1993 U240
Moderator, ForeForum 2001-
Moderator Diesel RV Club 2002-
Moderator, FMCA Forum 2009-2020
Chairman FMCA Technical Advisory Committee 2011-2020

 

Re: Running cable from back to front

Reply #3
The aluminium  part under the carpet you have turned up is what you are looking for.  Used a 1" hole saw and a 50' fish tape and had no problems.  Only had to back up tape 1 time and it went from front to back with no problems.  I never found any plastic plugs anywhere so I just drilled a hole on each end, being careful when I got almost through so as not to cut any wires that may be inside.  Used Rogers post from above also.

2000 GV320 4010 build #5712  2019-?
1999 Bounder 2000-2008
Bardstown, KY
🥃The Bourbon Capital of the World🥃