Re: Dash AC Blows Hot Air, AC compressor is not engaging at all but looks good
Reply #10 –
Agree with Jor, on my 99, the binary switch on the receiver/dryer was a high/low pressure one.
Put a Autozone gauge/charger on low side, if it reads above 5 lbs or so, you should have some freon left in system. pull trigger and low side should go up enough to engage clutch on compressor, if it does, add enough refrigerant so compressor stays running. If this works, use gauge to figure out how much pressure at your temp. to use. It will go faster if you do this at high idle. If this does not work, back to the drawing board.