Xantrex 2.5 help...
Any recommendations on some to verify my Xantrex prosign 2.5 in the dfw area?
I had a local shop repair previous owners aux air install... the wire was too low of a gauge and would trip the braker... that and 2 new starter batteries.
The storage facility only has 110v which I've been able to use to top off battries in the past. After the repair the everything looks good for A few min, the panel current goes to 70a the it goes dark, comes back with no faults to 20a, then repeats the process. Batt show 13.x volts, and it worked before.
Since I don't have the advanced panel I'm going to check the bulk/float settings... but the house batteries are similar to the PO's.
I thought it might be time to have a smart person check out however.
I put in 3x 8D trojen gel last summer, it's and I've not had this issue, although I know it's not and ideal situation.
Topic: Xantrex 2.5 help...