RUBBER SEALS ON DOCKING LIGHTS

Skip to main content ↑ ↓

Topic: RUBBER SEALS ON DOCKING LIGHTS (Read 327 times) previous topic - next topic

RUBBER SEALS ON DOCKING LIGHTS

June 13, 2021, 01:55:24 pm

Good day!
Does anyone have any insight on how to get the rubber seals (cups) off the original docking lights on my 1998 U320?
I would like to replace them with LED lights but cant seem to get the rubber cup off.
Peeter

Re: RUBBER SEALS ON DOCKING LIGHTS

Reply #1 – June 13, 2021, 03:34:33 pm

They are tight and stiff. Try running them under some hot water to soften them up. And then it is just pry them off as carefully as you can. A bit of silicon plumber's grease might help ease them back on.

Re: RUBBER SEALS ON DOCKING LIGHTS

Reply #2 – June 13, 2021, 10:05:22 pm

ok....although i will have to bring the hot water to it as the electrical goes thru the rubber casing to the bulb...lol

Re: RUBBER SEALS ON DOCKING LIGHTS

Reply #3 – June 13, 2021, 10:45:47 pm

If you have a heat gun try that, not much. I just carefully pried mine off.

Affiliate Notice

ForeForums is user-supported. When you purchase through some links on our site, we may earn an affiliate commission at no cost to you. As an Amazon Associate I earn from qualifying purchases.