Re: slide
Reply #5 –
Ok that happened to me and the pins hold not retract. The board in the box may have hit the cover and shorted the fuse. You need to put rubber not he top of the cover Also look in the wiring loom and you will find a 40 amp fuse. That fuse is what allows the pins to retract. It can be replaced and your slide pins might work after that but why it blew is the question. I had to go to HWH twice at 5 dollar fuel to figure this out. You r boards are loose and meed to be tightened maybe. It is a place to check at least as that fues controls the pin retract. The motor runs but the pins stay still and nothing happens right?