Water pump pulsing and fill switch malfunction
I drained the pink from my system yesterday and filled the water tank about an 1-8 full, just to flush the pink stuff completely. The fill switch located in the drivers side water bay came on, with the green indicator light , as normal. When I went to shut down the fill pump the green light would not go out. I then went into the coach and tried with the fill switch located In the bathroom and was successful in turning it off. Suggestions why This happened? I tried it twice and it did the same thing each time...
Also I noticed when the water pump was on it was cycling on and off when I turned the hot water taps on....this did not happen with the cold water on only. I replaced the water pump ( another post) and took the accumulator out as the newly installed shurflo 4048 does not require one, as stated by the manual and several folks on this forum. Was that because the Aqua hot was not on at the time, or is there another explanation? I have not touched the settings on the 4048 at all, leaving it at the factory setting. Suggestions??