Skip to main content ↑ ↓
Topic: Slide Rooms (Read 427 times) previous topic - next topic

Slide Rooms

I am unable to extend my slide outs.  After turning the slide key and red light comes on, I hear a clicking but slides do not extend. 
I hear the hydraulic solenoids click but pump does not operate.  I'm showing 13.8 volts at the pump. 
Does anyone know if there is a reset somewhere or have any advice how I can check it? 
2003 U320 42' coach 6065 Motorcader #18349

Re: Slide Rooms

Reply #1 –
Note per his profile, this is a 2003 U320.

Craig - you may want to create a signature so your coach information appears at the bottom of each of your posts.

When you turn the key, first the amber light should start blinking.  You should hear the aux compressor run as it's pulling vacuum on the slide bladders.  Once it achieves vacuum (since this is a 2003), the light should go solid.

Do you have this behavior?

Are you level (per the HWH control pad display)?  No "excess slope" light, correct?  You can't move the slides in an "excess slope" situation.

Transmission in N and parking brake set?  You can't move the slides without the parking brake set.

Learn every day, but especially from the experiences of others. It's cheaper!  - John C. Bogle

2000 U320 36' non-slide / WildEBeest Rescue
2003 U320

Re: Slide Rooms

Reply #2 –
Do you have a reset of your HWH to the left of the driver seat? If so, reset the HWH. If not , turn off the salesman switch and turn back on, should rest system.
Did you try retract as well as extend?

Tim Fiedler
Tim Fiedler    2025 LTV Unity MBL on Order
2000 Chevy Tracker 2 Door Convertible 4WD Now lifted 4.5"
1985 Citroen 2CV6 Charleston
Murphy Rebel on wheels with 175HP Titan
Cessna P337
1980 48' Westport MY (!/4 Share)

Re: Slide Rooms

Reply #3 –
Any updates?
Learn every day, but especially from the experiences of others. It's cheaper!  - John C. Bogle

2000 U320 36' non-slide / WildEBeest Rescue
2003 U320
 

Re: Slide Rooms

Reply #4 –
Slide pump electric motor part numbers
Come to think of it I had a similar problem. Ended up being a no cost repair. Failed ground in hydraulic  motor. Suspect you could have the same
Scott