Skip to main content ↑ ↓
Topic: Presure regulator (Read 1479 times) previous topic - next topic

Presure regulator

I had this regulator leak and I got a new one
I looked at an Air schematic and I see a pressure regulator on the hwy side of things
Does anyone know what pressure should be set at.
Things were leaking real bad when I took it of and could not tell what it was .
Does anyone know what pressure this should be set at?

Re: Presure regulator

Reply #1 –
I believe that is for the front air bags and should be set 60-65 

Re: Presure regulator

Reply #2 –
so the air bags pressure would be 65 max?

Re: Presure regulator

Reply #3 –
The reason for that is so that when the coach is airing up, the front and rear will come up more at the same time. The reason being that the front weighs less than the rear. The rear bags don't have a regulator, unless you have a tag axle and then the tag axle has a regulator.

Re: Presure regulator

Reply #4 –
i do have a tag axle

i will dive down there tomorrow and check the rear set up

Re: Presure regulator

Reply #5 –

Just replaced that one on our coach.  Get the orange compression set from amazon, it makes getting the air connector pretty easy.  Only hard part is the access with you on your back in the middle of the coach.  Block the coach up.  Ours was set at 60 PSI.  You might want to get several as there are a couple of those on the coach.

Primefit CR1401G Replacement Air Regulator with steel-Protected Gauge, 1/4"...

Amazon.com: Hotop 5 Pieces Disconnect Clips Fitting Slip Removal Tools...

As an Amazon Associate Foretravel Owners' Forum earns from qualifying purchases.

Re: Presure regulator

Reply #6 –
Quote from: DaBus –
Get the orange compression set from amazon, it makes getting the air connector pretty easy.
Using the appropriately sized open end wrench also works, and has the added (mechanical) advantage of a built-in "handle".

Re: Presure regulator

Reply #7 –
i only see one in the front of the coach i did nor see one in the rear.
i set it up at 60 psi  now the only thing left to do is service the hwh solenoids from the six pack.
i will order from hwh since i tried Ace and the o ring was a 1 mm larger creating a buckle

Re: Presure regulator

Reply #10 –
BTW, for those who just want to replace the 2 usual suspects in an HWH o-ring kit (RAP6554) and not do a full plunger rebuild, the o-ring numbers are in this post

Our leveling system problem

Re: Presure regulator

Reply #11 –
Quote from: Michelle –
BTW, for those who just want to replace the 2 usual suspects in an HWH o-ring kit (RAP6554) and not do a full plunger rebuild, the o-ring numbers are in this post:
I concur with Steve's O-ring size identification from 13 years ago.  I also listed HWH O-ring "sizes" in my rebuild thread from 8 years ago.  I found all the O-ring sizes were readily available, in both Nitrile and Viton, at local oilfield supply shops.  They also carry Super Lube - an excellent O-ring assembly lube - in small 3 oz tubes.  Highly recommended.

Working On My Six Pack

 

Re: Presure regulator

Reply #12 –
I also found the orings at a hydraulic repair shop. They were very reasonable in price.