Skip to main content ↑ ↓
Topic: Removing Salon Table after Logbook Slide Down into the Back (Read 376 times) previous topic - next topic

Removing Salon Table after Logbook Slide Down into the Back

Our logbook slipped behind the "pick-up-and-slide-down" salon table (co-pilot side between the bucket seat and the recliner. I've removed three screws in the back just above where the table slides down but it's not moving. How does this table come apart? I can't imagine that they've glued it all together since stuff sliding down that table and then down into the back of that (liquor?) cupboard has to be common.

Craig
1993 U225 36' Unihome GV with PACBRAKE exhaust retarder, Banks Stinger and Solar Panels.
Toad: 1999 Jeep Wrangler 2-door soft-top.

"No one has ever had to evacuate a city because the solar panels broke."

Re: Removing Salon Table after Logbook Slide Down into the Back

Reply #1 –
Inside the doors at the bottom are some screws. 3 I think. The whole contraption has to come off the wall.
1994 U280, Build 4490
Deming, NM.
 

Re: Removing Salon Table after Logbook Slide Down into the Back

Reply #2 –
Quote from: Twig –
Inside the doors at the bottom are some screws. 3 I think. The whole contraption has to come off the wall.

I have found (and removed) three long (3-inch) screws above the table (hidding by felt tabs). I'll have to look for three at the bottom inside the doors. I've also found screws vertically inside the doors at the top.

Thanks,
Craig
1993 U225 36' Unihome GV with PACBRAKE exhaust retarder, Banks Stinger and Solar Panels.
Toad: 1999 Jeep Wrangler 2-door soft-top.

"No one has ever had to evacuate a city because the solar panels broke."