Skip to main content ↑ ↓
Topic: How to remove the Non-Skid from the inside steps (Read 929 times) previous topic - next topic

How to remove the Non-Skid from the inside steps

Has anyone removed the non-skid "pad" from the steps on the inside of the coach? Ours is becoming very "used" looking and I'd like to replace them.  This is in a 2002 U320 and they cover the Corian steps.  And any ideas on where to buy the replacement "pads"?

Thanks

Tom & Bill

2013 Jeep Grand Cherokee

Re: How to remove the Non-Skid from the inside steps

Reply #1 –
When we replaced our "OUTSIDE" non skid pad we used a hair dryer to get a corner started, then slowly pulled the rest away. You will have some glue reidue left.  Many different solvents available, I do not know what is best to use on corian. Replacement pads are available from Encore RV in Nac.  Welcome to Encore Motorhomes  Hope this helps.
We are only strangers until we meet; however, some of us are stranger than others

Re: How to remove the Non-Skid from the inside steps

Reply #2 –
If you are not near Encore, or theirs are the wrong size, visit any shop that sells custom skateboards.  The non-skid that is used on the topside of a skateboard is the same stuff. 
Carol & Jeff Savournin
Usta have a '93 U225 36', Usta have a '95 U320 40', Usta have a '02 U320 40'
Usta have a 2006 Born Free, Usta have a 2011 Phoenix Cruiser
Usta have a 2012 Jeep Wrangler Unlimited 4dr
"Your time is limited, so don't waste it living someone else's life."  Steve Jobs

Re: How to remove the Non-Skid from the inside steps

Reply #3 –
I have hardwood for my step area, not corian.  My non-skid pads are getting dull looking also.  What I did was some heavy duty velcro and a piece of astroturf type door mat.  May look gaudy, but it sure keeps the dirt out!  You would not believe the dirt it holds.  You just peel it up when you want to shake it off outside.  Anyway, that is my gaudy fix.
1994 U225
build #4514
 

Re: How to remove the Non-Skid from the inside steps

Reply #4 –
I just removed the non-skid on my inside steps -- really grungy around the edges.  I was able to get an edge started and then just pulled.  It seemed that everytime I had to stop to take a breadth, there was glue residue where I restarted.  But no problem getting the glue off by using plenty of rubbing alcohol and a scotch scrubbing pad.  The pad even removed some scratches on areas not convered.  And the plastice came off in one piece.  It was about 80 degrees temp at the time so if you are in a cooler area - use the hair blower as suggested to warm it up.
Larry Rubin
2004 U295 38' build 6278
2014 Jeep Cherokee