Skip to main content ↑ ↓
Topic: Ramco Mirror Adjuster (Read 899 times) previous topic - next topic

Ramco Mirror Adjuster

The light for the adjuster for the curb side Ramco mirror is burnt out or loose.  I used to tap it and it would go back on.  Now it's off no matter what I do.  This light is on all the time once the ignition is engaged.  I looked at it, but decided to stop as I did not have a lot of time to work on it.  And, there are several wires that plug into this unit.

I need to label all these wires carefully so I can put it back together.  Has anyone ever changed out a light bulb in one of these?

Peter

Re: Ramco Mirror Adjuster

Reply #1 –
Peter,
I changed my bulb two years ago so the memory is a little dim (no pun intended).  You should see a small access panel on the unit that you have to remove to insert the bulb.  It uses bulb 1703 from FOT.  I do remember it took awhile for me to figure out where the access panel was located.  If I have some time I will try to pull the unit and refresh my memory.

Re: Ramco Mirror Adjuster

Reply #2 –
Brad is right.  It's a on the radius of one of the edges with a slight lip sticking out so you can use your finger nail or a screw driver.  That little module pulls out and on the end of it the bulb is plugged into it.

Re: Ramco Mirror Adjuster

Reply #3 –
Thanks guys...So I don't have to unplug all the wires and remove the unit to perform the bulb change?
Peter 

Re: Ramco Mirror Adjuster

Reply #4 –
Peter,
All the wires do not have to be pulled loose, at least on mine I had enough slack to work without removing.

Thanks,

Re: Ramco Mirror Adjuster

Reply #6 –
Peter,

Just changed one of mine recently and it is exactly as everyone said. Just feel for the little door and it will pop open and you will see the bulb. I replaced mine with a #2723 bulb from EiKO brand from O'reiley's .  Piece of cake!

Good Luck

Jerry
 

Re: Ramco Mirror Adjuster

Reply #7 –
Quote from: coastprt –
Peter,

Just changed one of mine recently and it is exactly as everyone said. Just feel for the little door and it will pop open and you will see the bulb. I replaced mine with a #2723 bulb from EiKO brand from O'reiley's .  Piece of cake!

Good Luck

Jerry
Jerry,
That's a good find...Thanks
Peter