Skip to main content ↑ ↓
Topic: Rear radio and bed lights question (Read 800 times) previous topic - next topic

Rear radio and bed lights question

I have a radio installed in the passenger side bedroom cabinet and two florescent lights above the bed.  These were installed at the factory as original equipment.  Neither work.  Everything else does.  Fuses are also OK. I have checked the wiring in the cabinet above the bed and everything is OK.  Before I dive into the wiring and start dismantling the coach would anyone know where they are fed from?  There is no obvious source.

Keith
Keith, Joyce & Smokey the Australian Cattle Dog
1995 U320 SE Extreme 40' WTBI Build # 4780, with a Honda CR-V hopefully still following behind.
Motorcade # 17030
FMCA # F422159

Re: Rear radio and bed lights question

Reply #1 –
If it is a sony radio, did you check the small fuse in the back of the radio? You have to remove the radio to find it. No help on the lights

Re: Rear radio and bed lights question

Reply #2 –
Thanks Steve.

I will check that fuse.  Hope I can get to it by sliding the radio from it's sleeve.  Can't see how to get at it otherwise.  I tried removing the screws in the shelf above the radio but nothing would move.  They sure build these Foretravels in a mysterious way!

Keith
Keith, Joyce & Smokey the Australian Cattle Dog
1995 U320 SE Extreme 40' WTBI Build # 4780, with a Honda CR-V hopefully still following behind.
Motorcade # 17030
FMCA # F422159

Re: Rear radio and bed lights question

Reply #3 –
Some radios have a frame installed, with the radio sliding into this frame.  Usually have a snap-off outer appearance fixture.  The after-market radios usually use two 'specialty tools', one on either side to depress the pins that hold the radio in the frame.  These are just a thin piece of metal that fits between the frame and radio and allows the radio to slide out of the frame by depressing the retaining pins.
Mike
Mike Brady
'97 U320 SE. #5137
'13 Honda Fit
Willow Springs, MO
 

Re: Rear radio and bed lights question

Reply #4 –
Quote from: Yetch –
Some radios have a frame installed, with the radio sliding into this frame.  Usually have a snap-off outer appearance fixture.  The after-market radios usually use two 'specialty tools', one on either side to depress the pins that hold the radio in the frame.  These are just a thin piece of metal that fits between the frame and radio and allows the radio to slide out of the frame by depressing the retaining pins.
Mike

Car stereo removal tools-in Plastic & Rubber Care from Automobiles & Motorcycles
The selected media item is not currently available.Barry BEAM #16014
2003 U320 40' AGDS
Beamalarm, Foretravel technical help and specifications
"Whatever the mind can conceive and believe, it can achieve"