Skip to main content ↑ ↓
Topic: Ignition lock bezel removal for our 1997 (Read 830 times) previous topic - next topic

Ignition lock bezel removal for our 1997

I purchased a new NAPA Echlin KS6603 ignition switch to replace our original switch.

Our switch is mounted to the dash with a chrome inset bezel with three dimples.

Anyone know an easy way to remove the original switch?  What tricks can be used to unscrew the bezel, only having the three dimples to work with?

I see inexpensive tools in the market place, but are  not sure they will fit our bezel dimples as no measurements are offered.

If I knew year and model of car did our ignition switch come from, I could search for the proper tool.

Re: Ignition lock bezel removal for our 1997

Reply #1 –
Barry, I could be wrong (think it happened once years ago!!) but surely it looks like the one that is on Barry's  Beam alarm FOT site on removing. Does yours have the little hole were bezel meets cetre tumbler, and if so I think you just push in a pin into the hole then the centre part seperates from it them you take off the bezel
Replacing Foretravel Ignition Switch
John H

Hope all is well with the 2 of you
Coachless, now use aircraft. 2003 Ford Travelair TC280 class C. Super shape. Just for 1 yr .
1994 Ford E350 ClassC,total renovation inside and out. Now sold.
2000 U295  36' Cummins 350 c/w Banks Stinger, Resonator upgrade,Solar, LED lites.Residential fridge with slide out pantry. Build 5674. Sold
ex 92 GV 022C ored Cummins. Sold
ex 95 GV240 cat 3116. Sold
2017 Mini cooper s & 2016 land Rover LR2 HSE  LUX.
jhaygarth@aol.com    SKP #130098
treat everyone as you would like to be.

Re: Ignition lock bezel removal for our 1997

Reply #2 –
You might be able to loosen the bezel by accessing the switch from the back side and turning it. Our switch was loose and just turning the ignition key would rotate the cylinder. I was able to tighten it by turning from the back.
Dick, '03 U320 40' Tag, 2 slides, Coach #6075
Full Timers
2009 Honda CR-V

Re: Ignition lock bezel removal for our 1997

Reply #3 –
Barry, The ignition switch on mine looks about the same and it is a GM switch.  MY METHOD, is to use a small tip screwdriver in one of the dimples and hold the bezel against its rotation, and reach behind the dash and loosen switch. OR you can use the same screwdriver in the dimples and tap it loose with a small hammer, once it moves it is only finger tight.
Gary B
 

Re: Ignition lock bezel removal for our 1997

Reply #4 –
Garys method is what I do. But first you usually have to take out the lock cylinder. Put the key in and turn to the acc position and put a pick in the small hole in the cylinder, wiggle the key and it will pop out. Mark
Mark Freeman 1995 grand villa, Brimson Mn
8.3 Cummins  G95 4709 40 WTBS U280 WE21