Skip to main content
Topic: Unknown Extra Wires and Connectors (Read 347 times) previous topic - next topic

Unknown Extra Wires and Connectors

When I removed the round wooden cup holder on the passenger side, I uncovered some extra wiring. One of the wire bundles ended in a four prong connector with nothing attached to it. It looks like it has one green wire (ground) and three white wires (+12 VDC). This obviously plugged into something at one time. Does anyone know what its purpose is, or where it connected?
 
When I removed the small cabinet/table behind the copilot seat, I uncovered two long pairs of wires. One in each pair was white, and one green. They were capped off and all partially enclosed in a split loom coil. I assume they provided 12 VDC, possibly to a light or two for the table top. They look like one pair goes from/to the front, and the other from/to the rear. At the moment I do not have a use for them and am thinking of removing them to make the new cable run less crowded. Does anyone know what its purpose was, or to what it was connected?
 
Thanks for any information y'all can provide,
 
Trent
Trent and Jean Eyler
2000  U295  4003  WTFE  ISC  350
Build#5603 MC#17385

Re: Unknown Extra Wires and Connectors

Reply #1
Trent, check the numbers on the wires against the page in your book that shows your extra wires. That might help you out.
Richard & Betty Bark & Keiko our Golden Doodle
2003 U320T 3820 PBDS
Build # 6215
MC # 16926
2016 Chevrolet Colorado 4X4 diesel

 

Re: Unknown Extra Wires and Connectors

Reply #2
I had forgotten about the wire numbers. I do not think they are originally unused wires. I am just trying to find out what they were/are for.
 
Checking the wire numbers to my wiring diagrams may answer at least part of that question.
 
Thanks,
 
Trent
Trent and Jean Eyler
2000  U295  4003  WTFE  ISC  350
Build#5603 MC#17385