Skip to main content ↑ ↓
Topic: Floppy Dash Vents  (Read 613 times) previous topic - next topic

Floppy Dash Vents

So the vents on your Grand Villa dash just spin round and round, won't stay put, just plain aggravating! You have tried making a shim to hopefully hold it in place but usually that is short lived.
 Here is how to fix them. Without breaking the bank, Without buying new ones.
First remove the 4 screws that hold it to the dash. Gently pull vent assembly out of dash. Not too far you do not have to disconnect the duct.
On each side you will see the pivot pins. Using a suitable tool gently push in on the pins and slip the louvered piece out.
Now take a heat gun and warm the pins so you can bend the plastic out. Do each side.
Note: it does Not take much heat!!
After it cools reinsert it into the duct until pins snap into place. Insert duct back into dash and reinstall screws. Waah Laah!!!! Now your vents will stay put! ^.^d
91 GV U300 Unihome 40' Build 3811
6V92TA Detroit

Re: Floppy Dash Vents

Reply #1 –
You know......
Your subject line had me all prepped to make some,  ummm, adult comments!
In restless dreams I walked alone.
Narrow streets of cobblestone.


'93 U225
Build 4337
'14 CRV Toad

Re: Floppy Dash Vents

Reply #2 –
Quote from: Moby –
You know......
Your subject line had me all prepped to make some,  ummm, adult comments!
Don't Hold Back!! We are All Adults!  Let Em Rip......lol :))
91 GV U300 Unihome 40' Build 3811
6V92TA Detroit

Re: Floppy Dash Vents

Reply #3 –
When I was an Acura Master Technician and had this problem we put a small/tight "O" ring on the pin. We usually used a pocket screwdriver to pry between the vent and its housing on one side. If still too loose, put 1 on the other side.

Re: Floppy Dash Vents

Reply #4 –
Quote from: 79cvx20 –
When I was an Acura Master Technician and had this problem we put a small/tight "O" ring on the pin. We usually used a pocket screwdriver to pry between the vent and its housing on one side. If still too loose, put 1 on the other side.


That is a good idea! Easier than what I did for sure
91 GV U300 Unihome 40' Build 3811
6V92TA Detroit

Re: Floppy Dash Vents

Reply #5 –
Without the rubber o-rings on the AC louvers up on the ceiling on our '89 the louvers just flop around also.
Nitehawk,  Demolition Lady, & our NEW master, Zippy the speeding BB cat.
1989 Grand Villa 36' ORED
Oshkosh chassis, 8.2 DD V8
2006 Saturn Vue AWD
 

Re: Floppy Dash Vents

Reply #6 –
Quote from: nitehawk –
Without the rubber o-rings on the AC louvers up on the ceiling on our '89 the louvers just flop around also.
Well Dang Be Done, Lernt something new today and will put that into effect,Never thought. Sometimes I must overthink repairs. Thanks for the Tips! ^.^d
91 GV U300 Unihome 40' Build 3811
6V92TA Detroit