Skip to main content ↑ ↓
Topic: 24-36in Interior light housing or complete fixture.  (Read 734 times) previous topic - next topic

24-36in Interior light housing or complete fixture.

 I have exposed florescents, 36 in long,  up behind the drapes. Pretty useless as they shine on the backside of the drapes /header.
 Does anyone have an extra housing with covers that I can mount under the cabinets and fill with LED s?

 Or  has anyone installed one of these;  RV Cargo Race Trailer Interior LED Ceiling Light Fixture 12v 60 leds | eBay
 Thanks,MM

Re: 24-36in Interior light housing or complete fixture.

Reply #1 –
Mike, I sent a PM.
Roger Engdahl and Susan Green
2001 U320 3610 #5879 (Home2) - 2014 Jeep Cherokee or 2018 F150
Hastings, MN

Re: 24-36in Interior light housing or complete fixture.

Reply #2 –
Hey Mike, I updated all my florescent lights to LED using the same equipment that was there. See the attached photos. I removed all the old ballasts and wires, then tied straight into the 12 volt system. Easy, but a little time consuming to do it carefully. I ordered the light strips on Amazon and they were pretty cheap. I ran two strips per light set, and wow what a difference it made. Very happy with the results.

Tim

1991 Grand Villa 36'
3208 Cat
Work full time, travel when we can.
Updating this classic, enjoying every minute.
 

Re: 24-36in Interior light housing or complete fixture.

Reply #3 –
I did pretty much the same .    I am 100% soldered tho. The issue is that I am missing about 4 ft of curbside housing, over my desk.
  I ordered  a cheap LED housings and hope to get the LED strips into it.
 
The only fluorescence left  are behind the drapes. Stupid place for them IMHO.