Re: Inverter problem I think? Xantrex SW3000 Reply #25 – October 14, 2019, 09:17:41 am Jim,Of course you are correct. I should have said that heat is produced only under high loads. Yes, heat builds slowly and dissipates slowly. Quote Selected
Re: Inverter problem I think? Xantrex SW3000 Reply #26 – October 14, 2019, 02:07:40 pm Before I tightened the connections on the battery post that where loose I shot them with IR gun and those two post were about 5 degrees hotter than the other posts. Not real satisfied with the install of batteries at the Orielly store. These batteries had a threaded post and they screwed a lead post onto the thread post and then my cables were attached to the lead post. These two connections were not lose from the cable to the lead post but the lead post was not tight on the threaded post. Got everything tightened up and here are the results.No Loadinside panel 12.9Battery 12.89Fuse both sides 12.85inverter 12.85With microwave on heated water for 2minside panel 11.6Battery 12.02Fuse both sides 11.79/11.78inverter 11.75At rest the battery came back up to 12.8 in 5mDoes this sound OK to you guys?One other thing I noticed is it seems like it takes a long time for the inverter to kick on after I have enabled it at the panel like 5+Minutes. The light on the remote panel comes on immediately after I enable it but no inverter power is getting to the microwave for 5+ minutes. Quote Selected
Re: Inverter problem I think? Xantrex SW3000 Reply #27 – October 14, 2019, 02:12:49 pm Quote from: Tommy D – October 14, 2019, 02:07:40 pmDoes this sound OK to you guys?Yes. Quote Selected 2 Likes
Re: Inverter problem I think? Xantrex SW3000 Reply #28 – October 14, 2019, 02:22:04 pm Sounds right to me. Quote Selected
Re: Inverter problem I think? Xantrex SW3000 Reply #29 – October 14, 2019, 03:36:51 pm 5 minutes seems like a long time for the inverter to kick on. I believe the ats is some of that time. Have you clocked it or just guessing? Quote Selected
Re: Inverter problem I think? Xantrex SW3000 Reply #30 – October 14, 2019, 08:14:00 pm Just guessing but it was for sure 4 minutes. I will clock it next time. Quote Selected
Topic: Inverter problem I think? Xantrex SW3000