Skip to main content ↑ ↓
Topic: Auxiliary lights (Read 1438 times) previous topic - next topic

Auxiliary lights

So my auxiliary  lights don't work, ever. So the print B-2179 shows power control wire 20B as Hdlt power to aux switch. 20B on switch has no power.  I do not show the dash headlight switch in my print. On my actual headlight switch there is two extra spade connection on the switch inboard side. Was there a harness on there before? And none of the wires on the switch are 20B
Scott

Re: Auxiliary lights

Reply #1 –
Does the ignition have to be on for them?

Re: Auxiliary lights

Reply #2 –
I don't see that they are connected although I have tried. Hi beam inboard yes. Circuit works if 20B Is powered up. Just can't find were it gets power from headlight switch

Re: Auxiliary lights

Reply #3 –
Only know headlight switch from wire list

Re: Auxiliary lights

Reply #4 –
The auxiliary lights only work with ignition on and I think low beam but not sure about that it could be high beam.

Re: Auxiliary lights

Reply #5 –
I will recheck after dinner.
Scott

Re: Auxiliary lights

Reply #6 –
I did not see 20b on hi or DLR Relay
Scott

Re: Auxiliary lights

Reply #7 –
Here is Canada we have to have driving lights so I put in and extra air switch in the parking brake air line so when the parking brake
is released the driving lights come on.

Re: Auxiliary lights

Reply #8 –
Aux lights as in daytime running lights or as in fog lights?

If DRLs, I believe you need the transmission in D for them to be powered.  At least that's how it was in our 2003 pre-headlight conversion.

Re: Auxiliary lights

Reply #9 –
Okay. So far there is no power to the switch wire 20B headlight circuit.
I have tried with lights on
Running lights on.
Hi beams on,
Ignition on,
The wiring diagram does not show low beam, however it does show DLR relay
. Low beams work
Hi beam works,
Center hi beams work with ignition on.
So were does the 20B Wire get it's power from?
 I did not try with trans in Drive, but can tomorrow.
I normally power the Aux light circuit control power of the Hi beam circuit, Hi beam turns everything on and off. It is convenient to run them that way, but these are fog lights.
Scott

Re: Auxiliary lights

Reply #10 –
Quote from: Dave and Nancy Abel –
Howdy Bill,  Attached may be the drawing..
Good Luck, Dave A
So wire 225 WH splices into wire 225-67 WH To headlight dimmer switch and 20B Auxiliary Lighting relay 5?
So my dimmer does work and I'll look in that area for 20B. For power.
Scott

Re: Auxiliary lights

Reply #11 –
Curiosity killed the cat. Went back out powered up coach. Ignition on, low beam on R5 relay reinstalled and fog lights work. They match the output of the 1991 ford headlights and are on the chopping block. Will replace with led light bar. I had purchased a extra one for my suburban but the coach currently trumps the other cars. Pack of coyotes in the back yard during my trip out. Always exciting, sounds like they got a rabbit.
Scott

Re: Auxiliary lights

Reply #12 –

Fog lights converted to driving lights. Not DOT legal. Fog lights operated on low beam circuit. Control wire 20B got power from 212-69. Moved wire to 203 control power for hi beam.
To operate the following must be met.
Ignition on
Aux switch selected
Lights placed to hi beam.
Can not operate driving lights without hi beam. Everything dims down with low beam selected. Or just the driving lights can be turned off and hi beams remain on. This is how other vehicles I own are set up and it works well for me driving in the desert
The led light bar is a curved bar with spot only LEDs. NO flood. Does not produce light that is distracting
Amazon.com: 6KLED BC180S-X 180W 32" Curved LED Light Bar Side-by-Side Quad...
I have this bar on my Dodge 3500 daily driver and very much like. Not a rigid but closest if found for the price. Being curved spreads the light more to left and right sides were those deer like to socialize. Good focus up and down unlike most.

As an Amazon Associate Foretravel Owners' Forum earns from qualifying purchases.

Re: Auxiliary lights

Reply #13 –
Mount

Re: Auxiliary lights

Reply #14 –
Anyone replace the big spotlight bulb on the roof with LEDs?

Pierce

Re: Auxiliary lights

Reply #16 –
DSD,

  Did those mounts come with the light or is that something you fabricated?

Re: Auxiliary lights

Reply #17 –
Cut filler plates out of .125 to fill hole left by fog lights the pushed up as high as practical. Supports out of same plate. Not a very big market for Foretravel light mounts
Scott

Re: Auxiliary lights

Reply #18 –
Quote from: dsd –
Fog lights converted to driving lights. Not DOT legal. Fog lights operated on low beam circuit. Control wire 20B got power from 212-69. Moved wire to 203 control power for hi beam.
To operate the following must be met.
Ignition on
Aux switch selected
Lights placed to hi beam.
Can not operate driving lights without hi beam. Everything dims down with low beam selected. Or just the driving lights can be turned off and hi beams remain on. This is how other vehicles I own are set up and it works well for me driving in the desert

Interesting.

For our vehicles, we appreciate having fog lights, which will only illuminate with low beams on, and go off with high beams.  But then we drive in conditions of fog (where high beams cause a problem and fog lights are needed), and can see a similar need in snow conditions (which we would not drive a coach in  ;)  )

A coach in a desert, though, doubt you see much fog.
 

Re: Auxiliary lights

Reply #19 –
Michelle, yes I agree about the need for fog lights, but in the past 600K miles I have been in patch fog a couple of times. Have never been in fog in the USA. But these are my driving habits, but I bet in the last five years I have hundreds of hours driving at night and regular use of non DOT lights, But never with someone in view ahead of me both oncoming and preparing to pass. EVER. I hate headlights that glare at me while driving and pass along that consideration to everyone on the road, but if the road is clear and traffic free I run them. Have saved me many times with cows, elk, horses, people, abandoned vehicles. With them sharing the hi beam circuit control it makes for convenient control. With wiring diagram modification sheet it will be easy to restore to stock if needed
Scott