Skip to main content ↑ ↓
Topic: Ride Height Valve Cover & Filter (Read 520 times) previous topic - next topic

Ride Height Valve Cover & Filter

I just replaced my ride height valve filters and covers. In my experience, these things last three to four years. The rubber splits on the edge and they eventually fall off. Mine looked good but when I laid hands on the covers they just slipped right off.

They are a bit difficult to get on. I put them in hot soapy water and turn them inside out. Then just screw with them until I can get em' to pop into place.

I bought mine from FindItParts @ $ $5.31 each. The number is RN10JE. I used to get them at NAPA but the parts guy told me they are unavailable nationwide.

Anyhow, if you haven't checked yours in a few years they are probably in bad shape.
jor

93 225
95 300
97 270
99 320

Re: Ride Height Valve Cover & Filter

Reply #1 –
I used rubber ladder feet with a piece of filter cut to fit. Probably 75 cents.
1994 U280, Build 4490
Deming, NM.

Re: Ride Height Valve Cover & Filter

Reply #2 –
Ould this be the same part for our 99- U320
Thanks
Chris
1999 U 320 DGFE
Build Number 5523
Chris & Elka Lang
In the field, Lonoke AR

Re: Ride Height Valve Cover & Filter

Reply #3 –
Quote
Would this be the same part for our 99- U320

Yes. They are all the same. Like Twig did, you can always make your own. I used those rubber chair leg tips one time but I prefer these stock covers.
jor
93 225
95 300
97 270
99 320
 

Re: Ride Height Valve Cover & Filter

Reply #4 –
thanks
Chris
1999 U 320 DGFE
Build Number 5523
Chris & Elka Lang
In the field, Lonoke AR