Skip to main content ↑ ↓
Topic: Antena ,long blade roof (Read 460 times) previous topic - next topic

Antena ,long blade roof

my coach has a winegard  and not sure what purpose does the wide blade antena has other than  rattling right above the cockpit.

can it be removed?

is it hard to seal the roof penetration?

how big is the roof penetration?
2003 Foretravel u320 build 6066
cummins 450 ism
2008 Jeep Cherokee Toad
former Country Coach Owner.
Part time Rv er
Never afraid to learn.

Re: Antena ,long blade roof

Reply #1 –
My cable broke at the connection to the antenna a while back. When I went to repair it the new connector was larger than the old and after I crimped it on it was loose.
I removed the antenna from the arms and have not had to deal with the rattling and bumping.
It's been over 6 months. I will try a different antenna before I put the old one back up.
Love the peace and quiet.
Frank & Daisy
NO LONGER  "looking for the perfect Foretravel
36' or less non slide preferred."  She has been found and is ours.
2003 U320 36' non slide  Unit 6103
Cummins ISM 450
Allison 4000MH

Re: Antena ,long blade roof

Reply #2 –
Quote from: danilaprepeleac –
1.  my coach has a winegard
2.  can it be removed?
3.  is it hard to seal the roof penetration?
4.  how big is the roof penetration?
1.  OK
2.  Yes
3.  No.  You will actually have two holes on the roof to seal - one for the antenna base and one for the cable penetration.  Make up a paper template that replicates the shape of the antenna base.  Mark the location of the existing screw holes in the template.  Copy the template onto a piece of thin sheet metal.  Affix the metal plate to the roof using liberal amounts of Dicor sealant and the original screws.  Do the same for the cable hole.  Remove the "antenna down" sensor from the roof and seal the screw holes with Dicor.  There will also be a hole in the ceiling inside the coach to deal with.  You can plug it with styrofoam to fill the hole, and camouflage with a small piece of suitably colored fabric.
4.  Not big...perhaps 2" diameter for the larger one?  I used metal plates as described above to cover the holes when I removed the OEM sat antenna from our coach roof.  See photos.

Self-Leveling Lap Sealants - Dicor Products

1993 U280 SE 40' WTBI, Build: 4359
C8.3 300hp, 6-Speed, Exhaust Brake
960 watts on the roof (6 x 160)
Sorento (or BOLT) on a Kar Kaddy SS
"Nature abhors a vacuum"

Re: Antena ,long blade roof

Reply #3 –
I swapped the Winegard antenna for a Jack antenna. Then I glued a piece of carpet to the 1" tubing, between the tubing and the roof.
No more noises.
Nitehawk,  Demolition Lady, & our NEW master, Zippy the speeding BB cat.
1989 Grand Villa 36' ORED
Oshkosh chassis, 8.2 DD V8
2006 Saturn Vue AWD

Re: Antena ,long blade roof

Reply #4 –
We went from a Winegard to Jack and now the big antenna. If the antenna is seated in the little V shaped guide, it won't rattle. Good tip from Nitehawk about the carpet. Also round filed all the cable and amplifier in the back and went with RG-6 everywhere. Just down from the roof to an amplifier in the front overhead compartment and RG-6 from there. Pretty easy but just takes a little time.

Pierce
Pierce and Gaylie Stewart
'93 U300/36 WTBI
Detroit 6V-92TA Jake
1140 watts on the roof
SBFD (ret)

Re: Antena ,long blade roof

Reply #5 –
I'll throw this out just for informational value.  My Wineguard didn't work well when I first got coach.  What I tried was changing the cable between antenna post and roof connection with RG-6 replacing the RG-59.  I cleaned the connections with a brass bristle brush and used a bit of dielectric grease.  The thing has worked flawlessly ever since.  When I have a little more ambition, I'll pull RG-6 throughout.

jk
Jack and Cathy
1992 U280 Unihome 36' Build #4034
Cummins 8.3 /  Allison MT647/ PacBrake
Apopka, FL / Barre Center, NY

Re: Antena ,long blade roof

Reply #6 –
When I bought my coach there was a Jack antenna and some material glued to the roof
so no rattling and then I shortened the antenna arms to make room for the solar and
glued different material down. There had been 2 different satellites on the roof and I
removed all the patches and epoxied all the holes. When I put in the residential fridge
the roof vent I glassed in the hole and the regel coated the roof. 
Peter and Frieda Morin
1999 36ft. U320 Foretravel
Build # 5436
1998 Suzuki Sidekick Sport
 

Re: Antena ,long blade roof

Reply #7 –

As others have stated. King Jack.  Fits the same hole, no noise, good reception.

Amazon.com: KING OA8500 Jack HDTV Directional Over-the-Air Antenna with...

As an Amazon Associate Foretravel Owners' Forum earns from qualifying purchases.
Mark & Bev
2001 U295 36' Slide
Cummins ISC 8.3 350HP
Build #5802
Jeep Wrangler Toad