Re: Main Fuel Hose Size Reply #25 – August 27, 2014, 07:25:57 pm Yes I do Roger. It is all closed up now and just carpet to put back down but I am taking a break now as it is hot today, 94f. I will draw it out and put measurements using cabinet and side wall as ref' points.Glad I did it so just the filter location to check out now another day. The one thing as I said is to be careful when cutting thru the fibreglass sheet as you should NOT allow blade to go past the underside of this sheet or you may be fixing some cut air lines. The other safer way would be to take tank end panel off and put a pce of wood along the top of tank and pry lightly on cables pipes etc to push away from this sheet. The silicone tape looks good and tight so I doubt any air is going to get in there if cracks should open up.JohnH Quote Selected
Re: Main Fuel Hose Size Reply #26 – August 28, 2014, 12:17:39 am John, how did you support the replaced board in the hole? Quote Selected
Re: Main Fuel Hose Size Reply #27 – August 28, 2014, 01:48:59 am I'd rather pull the tank than cut the floor.But I have no other option--I have tile floor! Quote Selected
Re: Main Fuel Hose Size Reply #28 – August 28, 2014, 08:46:39 am Quote from: Barry & Cindy – August 28, 2014, 12:17:39 amJohn, how did you support the replaced board in the hole?I was wondering the same thing.Roland Quote Selected
Topic: Main Fuel Hose Size