Skip to main content
Topic: Sewer Odor, roof sewer vent, air admitance valves inside... (Read 2422 times) previous topic - next topic

Re: Sewer Odor, roof sewer vent, air admitance valves inside...

Reply #25
Pulled the washer to replace the two AAVs.  On my coach, a wall is very close to the washer cabinet, so a bit more difficult.

Refer to pic #1:
I took both lower doors off, removed the door catches on the middle shelf from both top and bottom.  The top catches make it difficult to remove the top cabinet floor, the bottom latches can catch on the washer removal and install. At very bottom of washer is a carpeted retainer board. Take it out to pull washer drier forward and out. It has 3 screws under the top carpet, one middle  and one each side about 3" from the edge.  When I put the board back I used no screws - it is going to stay put just fine w/o screws.

Pic 2: Access to water valves.  Mine did not want to turn at all, and I did not force it. I went outside and turned off the water at the manifold.

Pic 3: Removed floor of top cabinet.  I had previously permanently removed the ceiling of the bottom cabinet - see no need for it.

Pic 4" I left water hoses and drain hose attached as they were long enough.  I took off the drier vent hose from the washer side.

Pic 5: new AAVs installed - both serve washer drain system. One close to the loop the drain hose makes (forms a p trap) and one close to the actual small p trap.  Two probably because other wise each p trap will syphon, plus more water volume in one shot from the washer than other locations.

The old AAVs had curling rubber seals as in pic from a previous post.  While I had the drier out I cleaned the vent hose to outside, and the actual drier vent. On drier remove hard outer plastic ring and shine light down rubber vent boot.  I used long needle nose pliers to pinch out some lint, and used vacumn with crevice tool while operating the drier for more air flow. Pulled a pretty good size lint ball out. 

For this location I would use only the more expensive Studor AAVs because of the hassle of pulling the washer drier. Longer lasting solution.


Next up Lippert Components 389381 White Roof Vent, (360 Siphon) . Sat or Sun install probably. Amazon prime delivery on Saturday.

Dan - Full timing since 2009
2003 U320 40' Tag 2 slide

Re: Sewer Odor, roof sewer vent, air admitance valves inside...

Reply #26
Additional note on the air admittance valves (AAV). Any coach with a vacuflush toilet system  will not have a AAV for the toilet. It could never achieve vacumn and shut off it did.

 The vent for "toilet" (black tank) is past the vacuflush in the basement, from black tank itself  to roof top vent.

  Toilet to vacuflush mounted in basement can have no air admittance  valve and still achieve vacumn to shut off the system. Once past the vacuflush it pushes into the black tank. Then the vent is from black tank to roof vent.
Dan - Full timing since 2009
2003 U320 40' Tag 2 slide