Skip to main content ↑ ↓
Topic: What is behind the fiberglass? (Read 794 times) previous topic - next topic

What is behind the fiberglass?

OK, here goes. Up under my patio awning where the fiberglass goes under the awning flex key channel, what is behind the fiberglass?
Glass insulation? Foam insulation? The steel tubing?
If I drill a 1/2" diameter hole about 1/2" below the flex key channel for an electrical wire, what may I run into?
Remember, this is a 1989 coach. It does not have all the fancy stuff the newer coaches have, such as redundancy of wiring going from front to rear of the coach.
As a matter of fact, there isn't any 120V up front at all and very little elsewhere. Just the absolute minimum basics.

Re: What is behind the fiberglass?

Reply #1 –
Norm,

Use a magnet to determine where the steel structure is.

Re: What is behind the fiberglass?

Reply #2 –
Thanks, Brett.
Just got back from an eight day outing and need to add some lights.
Also, the toilet came loose and I know the original mounting flange from FOT is "kaput/broke/old/ineffective, so new mount is in order. Dometic has Universal floor mounting kit for around $24 on Amazon.
Water heater control valve took a dump also. Guess it doesn't like a wet bath from the drain petcock. New Atwood part #91605.
Pipe nipple and coupler in near future.
My nice neat ramps have gone mussy so I will make new set.
Golly gee, just can't seem to get bored these days when one has a 31 year old coach.

Re: What is behind the fiberglass?

Reply #3 –
It's not a lot different with a 17 year old one Nitehawk. 

Re: What is behind the fiberglass?

Reply #4 –
Quote from: wolfe10 –
Use a magnet to determine where the steel structure is.
Pick up one of these little magnetic stud finders at most hardware stores, Lowes, HD, etc.

Works great on any of the coach walls or storage compartment walls to locate the steel frame members.


 

Re: What is behind the fiberglass?

Reply #5 –
I found the perfect place to drill a hole thru from the outside into the interior.
On the passenger side, just 3/8" to the rear of the front vertical seam cover on our 1989 GV and about 1" down from the flex key channel.
I drilled a 5/16" diameter hole thru and the drilled hole comes out between the cockpit cabinet and the L.R. forward cabinet.
No aluminum, no steel, no insulation inhibited my drill.
In fact, the hole is just below the vinyl ceiling material that extends down behind the cabinets.
 ^.^d