Skip to main content ↑ ↓
Topic: SeeLevel sensor lengths for 2000 m/y coach (Read 809 times) previous topic - next topic - Topic derived from Re: SeeLevel Install ...

SeeLevel sensor lengths for 2000 m/y coach

I grabbed the following from Bill B's install post since this was also on a 2000

Quote from: Bill B –
Used the standard 16 in strips on the black and grey tanks.  They were a little short so I mounted them about an inch from the top of the tanks. I could see that the top of the tanks are not perfectly flat.  The strips are about 3 inches off the tank bottom.  I was more concerned when tank full than when empty.  The fresh water tank I used two 12 in strips and cut one section off bottom of each one.  Measures from just below the overflow hose to about 2 inches off bottom. 

I'm getting ready to order our SeeLevel (709-N2K so we can interface with a Victron Cerbo GX.  Yes, we realize this model doesn't have an LP sensor).

Looking at the angle of our black and grey tanks (the wedge base that tilts the tanks 2 inches lower on the output side), we're thinking 2 stacked AR sensors (9" models with 1" increments, cut as needed) each for those tanks, and then the 2 ES2 12" sensors stacked for the fresh tank.

Anyone see an issue with this sensor plan?
 

Re: SeeLevel sensor lengths for 2000 m/y coach

Reply #1 –
Sounds like that would work and give you more precise empty / full readings than my install.  Good luck!